Effect of specimen geometry, gage length, and width measurement locations on plastic strain ratio (R-value) in sheet metals
Authors:
- 1 December 2006
- journal article
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 37 (12) , 3477-3487
Abstract
No abstract availableKeywords
This publication has 25 references indexed in Scilit:
- Compensation of elastic strains in the determination of plastic strain ratio (R) in sheet metalsMaterials Science and Engineering: A, 2005
- Simulation of plastic anisotropy in IF deep-drawing steels by Taylor theoryMaterials Letters, 2004
- A unified test for evaluating material parameters for use in the modelling of sheet metal formingJournal of Materials Processing Technology, 2001
- Direct Evaluation of Sheet Metal Forming Properties under Various Deformation ConditionsKey Engineering Materials, 2000
- Determination of the plastic anisotropy r in sheet metal using automatic tensile test equipmentJournal of Materials Processing Technology, 1998
- Finite-Element Prediction of Heterogeneous Material Flow during Tensile Testing of Anisotropic MaterialMaterials Science Forum, 1994
- Plastic Strain Ratio (r) for Sheet Metal: Effect of Gage Length and Width Measurement Locations Using Reduced Section SpecimensJournal of Testing and Evaluation, 1990
- r-values of Ti–6Al–4V sheet after superplastic strainMaterials Science and Technology, 1987
- A simplified method of determining the strain-ratio (R-value) in aluminum alloysMetallurgical Transactions, 1973
- The variation of the r-value in titanium with increasing strainInternational Journal of Mechanical Sciences, 1972