Failure Modes of Bolted-Sheet-Steel Connections Loaded in Shear
- 1 March 2000
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 126 (3) , 288-296
Abstract
To ensure that accurate failure-mode assessments are made, and ultimately to ensure that accurate design equations are formulated, a detailed analysis is needed of the procedure used to identify the cause of a connection failure. Misidentification of failure modes and the misuse of data can lead to serious errors in the accuracy and applicability of design equations. The load-capacity formulations presented in the American Iron and Steel Institute (AISI) Specification cannot be used to accurately predict the failure modes of thin cold-formed sheet-steel bolted connections that are loaded in shear. A modification to the bearing-coefficient provisions, to account for the reduced bearing resistance of the connected materials, is necessary and has been proposed by the writers in recent papers. A revision of the net-section fracture design method is also required. Recommendations concerning the procedure that is used to identify the net-section fracture and bearing-failure modes are made in this paper.Keywords
This publication has 9 references indexed in Scilit:
- Bolted connection design for sheet steels less than 1.0 mm thickJournal of Constructional Steel Research, 1999
- Bearing Design of Cold Formed Steel Bolted Connections1999
- Bolted Connection Tests of Thin G550 and G300 Sheet SteelsJournal of Structural Engineering, 1998
- Ductility of G550 Sheet Steels in TensionJournal of Structural Engineering, 1997
- Behavior of low ductility steels in Cold-Formed Steel connectionsThin-Walled Structures, 1996
- Thin Light-Gage Bolted Connections Without WashersJournal of the Structural Division, 1979
- Light-Gage Steel Bolted Connections without WashersJournal of the Structural Division, 1975
- Suggested Steel Ductility RequirementsJournal of the Structural Division, 1974
- Tests on Bolted Connections in Light Gage SteelJournal of the Structural Division, 1956