Evaluation of Single Lane Parallel-Type Entrance Ramp Terminal Using Vehicle Dynamics Model for Freeways
Open Access
- 1 March 2023
- journal article
- research article
- Published by Walter de Gruyter GmbH in Architecture, Civil Engineering, Environment
- Vol. 16 (1) , 85-100
Abstract
Providing an appropriate length of highway entrance ramps is an important feature that should be considered in freeway design. The recommended minimum acceleration lane length in the Green Book of the American Association of State Highway and Transportation Officials (AASHTO) is currently used for designing entrance ramp terminals. However, in some cases, traffic congestion and crashes are observed when heavy trucks enter freeways, which indicates they could not accelerate enough and did not reach the merge speed at the end of the acceleration lane. Therefore, several scenarios were simulated using a dynamic simulation model (TruckSim) for heavy vehicles with weight to power ratios of 61, 67, 86, and 108 (kg/kW) and grades of zero, ±3, and ±5%. Subsequently, a linear regression model was presented to calculate acceleration lane lengths. The results showed that the acceleration rate of heavy vehicles is not adequate, especially in upgrades. For example, at +5% upgrades, heavy trucks cannot accelerate to the merge speed mentioned in the AASHTO. Conversely, the acceleration rate of heavy vehicles increased in downgrades; therefore, some heavy vehicles were able to achieve merge speed along the proposed length of AASHTO.Keywords
This publication has 6 references indexed in Scilit:
- Modeling of Lateral Stability of Tractor-Semitrailer on Combined Alignments of FreewayDiscrete Dynamics in Nature and Society, 2018
- Design Guidance for Freeway Mainline Ramp Terminals2012
- Analyzing the influence of median cross-section design on highway safety using vehicle dynamics simulationsAccident Analysis & Prevention, 2010
- Potential Changes to 2004 Green Book's Adjustment Factors for Entrance and Exit TerminalsTransportation Research Record: Journal of the Transportation Research Board, 2007
- Vehicle Dynamics Model for Estimating Maximum Light-Duty Vehicle Acceleration LevelsTransportation Research Record: Journal of the Transportation Research Board, 2004
- Vehicle Dynamics Model for Predicting Maximum Truck Acceleration LevelsJournal of Transportation Engineering, 2001