An Experimental Investigation into Roughness Transfer in Asymmetrical Rolling of Steel Strips
Open Access
- 15 September 2023
- journal article
- research article
- Published by Karadeniz Fen Bilimleri Dergisi in Karadeniz Fen Bilimleri Dergisi
- Vol. 13 (3) , 1070-1089
Abstract
This study investigated the effect of rolling parameters such as speed, thickness reduction, roll surface roughness, material thickness, surface condition (dry or lubricated), and rolling force on the roughening characterization in asymmetrical rolling. The surface roughness of the samples subjected to rolling tests was measured. The roughness values' average and standard deviation were found, and 3-D scanning images were acquired. Lubricated texturing experiments revealed that lubrication reduced roughness transfer. It was found that the introduction of roughness on the material surface decreased as the rolling speed increased. On the other hand, a higher speed increases the rolling force, which increases the surface roughness. The effect of speed on the standard deviation varies in direct proportion. Furthermore, lubricated rolling produced a more homogenous roughness distribution at higher speeds, while dry rolling produced homogeneous roughness at lower speeds. It was revealed that the rolling force is higher with thicker materials. While the roll roughness did not affect the rolling force using thicker material much, this effect was more pronounced in the very rough roll using thinner material. The standard deviation was lower in smaller reduction ratios using rough and very rough rolls. According to the results, although asymmetrical rolling has some advantages compared to conventional rolling, it was concluded that it is not a suitable method for roughening steel strips.Keywords
Funding Information
- Karabük Üniversitesi (KBÜBAP-22-YL-052)
This publication has 25 references indexed in Scilit:
- A generic model for surface texture development, wear and roughness transfer in skin pass rollingWear, 2015
- Influence of roll radius on roughness transfer in skin-pass rolling of steel stripJournal of Materials Processing Technology, 2014
- Asymmetric Rolling of Interstitial-Free Steel Using Differential Roll Diameters. Part I: Mechanical Properties and Deformation TexturesMetallurgical and Materials Transactions A, 2013
- Texture and microstructure evolution during the symmetric and asymmetric rolling of AZ31B magnesium alloysMaterials Science and Engineering: A, 2013
- Influence of asymmetric hot rolling on microstructure and rolling force with austenitic steelTransactions of Nonferrous Metals Society of China, 2012
- The effects of asymmetrical cold rolling on kinetics, grain size and texture in IF steelsMaterials Characterization, 2009
- Printing Behavior of Roll Surface Texture to Hot-dip Galvanized Steel Sheet in Temper RollingTetsu-to-Hagane, 2009
- An analytical approach for modelling asymmetrical hot rolling of heavy platesMathematical and Computer Modelling of Dynamical Systems, 2008
- A study on the characteristics of electrical discharge textured skin pass mill work rollSurface and Coatings Technology, 2008
- Bulk deformation processes1999