Analysing Double Shearing Mechanism in Fiberglass Rock Bolting Systems: a Comprehensive Analytical Model and Numerical Simulation Approach
Open Access
- 11 September 2024
- journal article
- research article
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 42 (8) , 7339-7370
Abstract
An analytical method and numerical simulation were developed to investigate the shear performance of fiberglass rock bolts (20-tonne and 30-tonne) by conducting sixteen double-shearing tests with both clean and infilled shear interfaces. Following the preparation of the required samples, each test set-up was subjected to different ranges of pretension values. The infilled scenario involved 5 mm thick sandy clay infilled shear interfaces. The results of the double shearing tests unveiled that as pretension increased, so did the confining pressures at the shear interfaces for both clean and infilled joints. Also, an analytical model was developed utilising the Fourier transform, energy balance theory, and linear elastic theory. The result was an empirical relationship that could determine the double shear performance of fibreglass rock bolts in close agreement with the experimental data. Coefficients were incorporated to facilitate model calibration and tuning. Eventually, fast Lagrangian analysis of continua (FLAC) three-dimensional (3D) modelling was utilised to conduct numerical simulations of fibreglass rock bolts subjected to double shearing scenarios. The numerical model was calibrated against experimental data and then extended to conduct a sensitivity analysis on fibreglass rock bolts subjected to double shear test setup variations. Scenarios included rock bolt installation angles, shearing rates, and various host rock strengths. The results revealed that increasing the shear speed from the experimental test baseline yielded substantial displacement increases in the post-failure residual performance of the rock bolts. Changing the installation angle resulted in greater peak shear forces and extended residual zones. The least significant impacts were observed when changing the host rock UCS, suggesting neither rock bolt was drastically impacted by weak or strong host rocks.Keywords
Funding Information
- University of Southern Queensland
This publication has 38 references indexed in Scilit:
- Predicting axial-bearing capacity of fully grouted rock bolting systems by applying an ensemble systemSoft Computing, 2024
- Predicting grout’s uniaxial compressive strength (UCS) for fully grouted rock bolting system by applying ensemble machine learning techniquesNeural Computing and Applications, 2024
- Investigation on the pullout bearing properties and stress characteristics of fully grouted bolts in layered rock massEnergy Science & Engineering, 2024
- Effect of Contributing Parameters on the Behaviour of a Bolted Rock Joint Subjected to Combined Pull-and-Shear Loading: A DEM ApproachRock Mechanics and Rock Engineering, 2019
- Performance of a New Yielding Rock Bolt Under Pull and Shear Loading ConditionsRock Mechanics and Rock Engineering, 2019
- Effects of Cyclic Loading on the Shear Behaviour of Infilled Rock Joints Under Constant Normal Stiffness ConditionsRock Mechanics and Rock Engineering, 2013
- Analytical model for the mechanical behaviour of bolted rock joints subjected to shearingRock Mechanics and Rock Engineering, 1996
- Action of fully-grouted bolts in jointed rock and factors of influenceRock Mechanics and Rock Engineering, 1990
- Reinforcement analysis and design of mechanical roof bolting systems in horizontally bedded mine roofsGeotechnical and Geological Engineering, 1985
- Roof bolting in underground mining: a state-of-the-art reviewGeotechnical and Geological Engineering, 1984