Numerical Study and Experimental Investigation of Solidification Phenomena in Semi-Continuous Casting of Bronze
- 1 October 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 154-155, 1401-1404
Abstract
In semi condinuous casting of technincal bronze alloys homogenuous microstructure is very important for the assurance of material properties. The improvement of the knowledge about both, thermodynamics of the ternary system Cu-Sn-P and the solidification process is of main interest for the involved industry. To describe solidification of these alloys, the ternary system Cu-Sn-P in the Cu-rich corner is experimentally investigated. DSC measurements, diffusion and annealing experiments have been performed and compared with computational thermodynamics based on the Calphad approach. The so defined thermodynamic information is coupled with solidification simulation. For this, CFD calculations are done with a two phase solidification model including mass, momentum, energy and concentration transfer and applied to semi-continuous casting of technical Bronze alloys. The predicted macrosegregation pattern is in good qualitative agreement with experimentally observed result.Keywords
This publication has 5 references indexed in Scilit:
- On the Formation of Macrosegregations in Steel Ingot CastingsSteel Research International, 2008
- Using a Three-Phase Deterministic Model for the Columnar-to-Equiaxed TransitionMetallurgical and Materials Transactions A, 2007
- A three-phase model for mixed columnar-equiaxed solidificationMetallurgical and Materials Transactions A, 2006
- Modeling of globular equiaxed solidification with a two-phase approachMetallurgical and Materials Transactions A, 2002
- Thermodynamic description of CuSnP system in the copper-rich cornerCalphad, 2001