Impact of process parameters on dissimilar welding of metal joining: Using DOE
Open Access
- 1 January 2023
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2721 (1)
Abstract
The most useful method for dissimilar welding of metal joining is, MPW. The reason behind this is, it uses induced currents in opposite direction, EMF across the flowing current in the specimen and the working coil respectively. In order to get MPW effectively the process parameters must be selected optimally. Some of the variables viz. distance between specimens, workpiece’s thickness and charge voltage. In this study, the aim is to find the impact of these process parameters on the Al/Cu joint by making use of DOE. To estimate the value for leakage pressure, a mathematical model is also developed. DOE was employed with the center composite design. A1070 and C1221are the materials used for copper rod and aluminum tube resp. Following the sequential test, a leakage test was carried out to check the welding performance. The estimated and the measured results are in good agreement thus this developed model is a good choice for presence of leakage. For MPW, the consistency of the joint is greatly affected by the charge voltage as obtained from this study.Keywords
This publication has 16 references indexed in Scilit:
- Dissimilar Friction Stir Welds in AA2219-AA5083 Aluminium Alloys: Effect of Process Parameters on Material Inter-Mixing, Defect Formation, and Mechanical PropertiesTransactions of the Indian Institute of Metals, 2015
- The optimization of friction spot welding process parameters in AA6181-T4 and Ti6Al4V dissimilar jointsMaterials & Design, 2015
- Experimental and numerical analysis on aluminum/steel pipe using magnetic pulse weldingMetals and Materials International, 2011
- Joining of Aluminum to Steel Pipe by Magnetic Pulse WeldingMATERIALS TRANSACTIONS, 2011
- Effects of the Stand-off Distance on the Weld Strength in Magnetic Pulse WeldingJournal of Welding and Joining, 2008
- Response surface methodology for the modelling of copper removal from aqueous solutions using micellar-enhanced ultrafiltrationJournal of Membrane Science, 2008
- Effect of Gap on Seam Welding by Applying Magnetic PressureJournal of the Japan Society for Technology of Plasticity, 2006
- Microstructures at Aluminum - Copper Magnetic Pulse Weld InterfacesMaterials Science Forum, 2003
- Bonding zone formation in magnetic pulse weldsScience and Technology of Welding and Joining, 2002
- Magnetic impulse welding of aluminium tube and copper tube with various core materialsWelding International, 1998