Formaldehyde Sensing Characteristics of a NiO-Based Sensor Decorated With Pd Nanoparticles and a Pd Thin Film
- 2 April 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 65 (5) , 1956-1961
Abstract
A Pd nanoparticle (NP)/Pd film/NiO film structure, prepared with both drop-coating and RF sputtering approaches, is reported to fabricate a formaldehyde gas sensor. As compared to pristine NiO layers, the use of Pd NPs and Pd thin film is shown to enhance the catalytic capability and related sensing performance. Experimentally, a high sensing response of 10.1 is obtained under introduced 20 ppm HCHO/air gas at 250 °C. Moreover, a very low detection level of 16 ppb HCHO/air is acquired. The optimal operating temperature is 250 °C. Due to the nonuniform distribution or agglomeration effect of Pd NPs, a relatively slow sensing speed is found. Based on the superior performance indicated earlier and advantages including low cost, easy fabrication, and chemical stability, the studied device is promising for formaldehyde sensing applications.Keywords
Funding Information
- Ministry of Science and Technology of the Republic of China (NSC-100-2221-E-006-244-MY3)
- Advanced Optoelectronic Technology Center, National Cheng Kung University
This publication has 33 references indexed in Scilit:
- Some technological properties of wood–styrofoam composite panelsComposites Part B: Engineering, 2013
- ZnO–SnO2 nanotubes surface engineered by Ag nanoparticles: synthesis, characterization, and highly enhanced HCHO gas sensing propertiesJournal of Materials Chemistry C, 2013
- Studies of influence of structural properties and thickness of NiO thin films on formaldehyde detectionThin Solid Films, 2011
- Formaldehyde sensing properties of electrospun NiO-doped SnO2 nanofibersSensors and Actuators B: Chemical, 2011
- Fundamental studies and perceptions on the spillover mechanism for hydrogen storageChemical Communications, 2011
- TG-FTIR study on urea-formaldehyde resin residue during pyrolysis and combustionJournal of Hazardous Materials, 2010
- Study on a micro-gas sensor with SnO2–NiO sensitive film for indoor formaldehyde detectionSensors and Actuators B: Chemical, 2008
- Enhanced sensing characteristics in MEMS-based formaldehyde gas sensorsMicrosystem Technologies, 2007
- Enhanced Gas Sensing by Individual SnO2 Nanowires and Nanobelts Functionalized with Pd Catalyst ParticlesNano Letters, 2005
- Long-term stability of urea-formaldehyde foam insulationEnvironmental Science & Technology, 1980