Validations of CFD against detailed velocity and pressure measurements in water turbine runner flow
- 21 February 2003
- journal article
- research article
- Published by Wiley in International Journal for Numerical Methods in Fluids
- Vol. 41 (8) , 863-879
Abstract
This work compares CFD results with experimental results of the flow in two different kinds of water turbine runners. The runners studied are the GAMM Francis runner and the Hölleforsen Kaplan runner. The GAMM Francis runner was used as a test case in the 1989 GAMM Workshop on 3D Computation of Incompressible Internal Flows where the geometry and detailed best efficiency measurements were made available. In addition to the best efficiency measurements, four off‐design operating condition measurements are used for the comparisons in this work. The Hölleforsen Kaplan runner was used at the 1999 Turbine 99 and 2001 Turbine 99—II workshops on draft tube flow, where detailed measurements made after the runner were used as inlet boundary conditions for the draft tube computations. The measurements are used here to validate computations of the flow in the runner.The computations are made in a single runner blade passage where the inlet boundary conditions are obtained from an extrapolation of detailed measurements (GAMM) or from separate guide vane computations (Hölleforsen). The steady flow in a rotating co‐ordinate system is computed. The effects of turbulence are modelled by a low‐Reynolds number k‐ω turbulence model, which removes some of the assumptions of the commonly used wall function approach and brings the computations one step further.The computational results are compared to the measurements with respect to detailed velocity and pressure distributions at several measurement sections and several operating conditions. The computational results are also compared to coarse grid wall function computations by the TASCflow CFD code, which uses a similar methodology as the CALC‐PMB CFD code used in the present work. The comparisons show where the computational method is sufficient and where it is not sufficient.The behaviour of the computational method is similar for both kinds of water turbines, which shows that experience of computations in water turbines will ultimately give quantitatively correct results. Copyright © 2003 John Wiley & Sons, Ltd.Keywords
This publication has 9 references indexed in Scilit:
- Analysis of flow in the plate-spiral of a reaction turbine using a streamline upwind Petrov-Galerkin methodInternational Journal for Numerical Methods in Fluids, 2000
- Second-Moment Turbulence Closures for CFD: Needs and Prospects∗International Journal of Computational Fluid Dynamics, 1999
- Experimental Flow Study of the GAMM Turbine Model1993
- Viscous Flow Analysis as a Design Tool for Hydraulic Turbine ComponentsJournal of Fluids Engineering, 1990
- Instability1990
- Reassessment of the scale-determining equation for advanced turbulence modelsAIAA Journal, 1988
- ENHANCEMENTS OF THE SIMPLE METHOD FOR PREDICTING INCOMPRESSIBLE FLUID FLOWSNumerical Heat Transfer, 1984
- Numerical study of the turbulent flow past an airfoil with trailing edge separationAIAA Journal, 1983
- Towards the ultimate conservative difference scheme. II. Monotonicity and conservation combined in a second-order schemeJournal of Computational Physics, 1974