Optimization of Cutting Data and Tool Inclination Angles During Hard Milling with CBN Tools, Based on Force Predictions and Surface Roughness Measurements
Open Access
Abstract
This work deals with technological considerations required to optimize the cutting data and tool path pattern for finishing the milling of free-form surfaces made of steel in a hardened state. In terms of technological considerations, factors such as feed rate, workpiece geometry, tool inclination angles (lead and tilt angles) and surface roughness are taken into account. The proposed method is based on calculations of the cutting force components and surface roughness measurements. A case study presented in the paper is based on the AISI H13 steel, with hardness 50 HRC and milling with a cubic boron nitride (CBN) tool. The results of the research showed that by modifications of the feed value based on the currently machined cross-sectional area, it is possible to control the cutting force components and surface roughness. During the process optimization, the 9% and 15% increase in the machining process efficiency and the required surface roughness were obtained according to the tool inclination angle and feed rate optimization procedure, respectively.Keywords
This publication has 30 references indexed in Scilit:
- Optimisation of machining parameters during ball end milling of hardened steel with various surface inclinationsMeasurement, 2017
- Precision Milling of Hardened Steel with CBN ToolsKey Engineering Materials, 2013
- Economical and technological study of surface grinding versus face milling in hardened AISI D3 steel machining operationsInternational Journal of Production Economics, 2012
- A study on cubic boron nitride (CBN) milling of hardened cast iron for productive and quality manufacturing of machine tool structural componentsThe International Journal of Advanced Manufacturing Technology, 2012
- Cutting performance of PVD-coated carbide and CBN tools in hardmillingInternational Journal of Machine Tools and Manufacture, 2011
- Development of ultra-fine-grain binderless cBN tool for precision cutting of ferrous materialsJournal of Materials Processing Technology, 2009
- Experimental investigation of cutting tool performance in high speed cutting of hardened X210 Cr12 cold-work tool steel (62 HRC)Materials & Design (1980-2015), 2005
- Capability Profile of Hard Cutting and Grinding ProcessesCIRP Annals, 2005
- Determination of manufacturing technologies in mould manufacturingJournal of Materials Processing Technology, 2004
- Decision algorithm for selection of high-speed machining, EDM or a combination for the manufacture of injection mouldsInternational Journal of Production Research, 2002