Properties of aggregate fines influencing modulus and deformation behaviour of unbound aggregates
- 5 June 2019
- journal article
- research article
- Published by Taylor & Francis in International Journal of Pavement Engineering
- Vol. 22 (4) , 498-513
Abstract
Unbound aggregate base and subbase layers distribute traffic induced wheel loads in a pavement and protect the weak subgrade. In this study, effects of plasticity index (PI), fines content (FC) (per cent passing No. 200 sieve size) and dust ratio (DR) (ratio of per cent passing No. 200 sieve to per cent passing No. 40 sieve) of unbound aggregates on the base/subbase layer modulus and deformation characteristics are investigated. Repeated load triaxial tests were conducted on crushed gravel and limestone specimens prepared at optimum moisture contents for two Illinois dense-graded gradations, i.e. CA 6 and CA 2, to determine the resilient modulus and deformational behaviour. Samples with 9% PI showed lower resilient moduli and greater deformations than samples with 5% PI. The effects of FC on the modulus and deformation behaviour depend on the DR. Increasing DR from 0.4 to 0.6 and eventually to 1.0 increased deformations and decreased resilient moduli at the FC of 5%. An opposite trend was observed when the DR increased from 0.4 to 0.6 and eventually to 1.0 at 12% FC. The test results were used to develop improved resilient modulus and deformation prediction models, which capture important effects of aggregate FC, PI and DR.Keywords
This publication has 12 references indexed in Scilit:
- Strength characteristics of crushed gravel and limestone aggregates with up to 12% plastic fines evaluated for pavement base/subbase applicationsTransportation Geotechnics, 2018
- Crushed Limestone Aggregate Strength Influenced by Gradation, Fines Content, and Dust RatioJournal of Transportation Engineering, Part B: Pavements, 2018
- Effect of plasticity index and dust ratio on moisture-density and strength characteristics of aggregatesTransportation Geotechnics, 2016
- Practices for Unbound Aggregate Pavement Layers2013
- Aggregate Physical Properties Affecting Modulus and Deformation Characteristics of Unsurfaced PavementsJournal of Materials in Civil Engineering, 2012
- Aggregate Morphology Affecting Resilient Behavior of Unbound Granular MaterialsTransportation Research Record: Journal of the Transportation Research Board, 2006
- Permanent Deformation in Flexible PavementsJournal of Transportation Engineering, 2004
- Modelling permanent deformation behaviour of unbound granular materialsConstruction and Building Materials, 1998
- Prediction of Permanent Deformation in Flexible Pavement Materials1989
- Principles of Pavement Design1975