Rheology‐processing‐property relationships in tubular blown film extrusion. I. High‐pressure low‐density polyethylene
Authors:
- 1 November 1983
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 28 (11) , 3399-3418
Abstract
Three different grades of high‐pressure low‐density polyethylene resin were used to establish relationships between tubular film blowability and the molecular parameters, namely, the molecular weight distribution (MWD) and the degree of long‐chain branching (LCB), and also between the processing conditions and the mechanical properties of the tubular blown films produced. For the study, both the shearing and elongational flow properties of the resins were determined. During the tubular film blowing experiment we measured the freeze‐line position, the tubular bubble diameter, the takeup speed, the axial tension, the pressure inside the tubular bubble, and the mass flow rate of the resin. The thickness of the tubular blown films was measured from the samples collected. In order to determine the tubular film blowability, we measured the maximum takeup speed at which the tubular blown bubble broke, for various blowup ratios. The measurements described above permitted us to calculate the tensile stresses at the freeze line, in both the machine and transverse directions, and they were found to be correlatable to the processing conditions employed. It has been found that the tubular film blowability is increased as the resin's MWD becomes narrower and the degree of LCB is less. It has been found further that a resin having lower elongational viscosity tends to give a greater draw‐down ratio, indicating a better tubular film blowability. Finally, the tensile properties of the tubular blown films were found correlatable to the processing variables, namely, blowup and takeup ratios.Keywords
This publication has 31 references indexed in Scilit:
- Orientation and morphology of high‐density polyethylene film produced by the tubular blowing method and its relationship to process conditionsJournal of Polymer Science: Polymer Physics Edition, 1982
- Some small-angle x-ray diffraction measurements on blown polyethylene filmsJournal of Applied Polymer Science, 1978
- X‐ray diffraction orientation studies on blown polyethylene films. III. High‐stress crystallization orientationJournal of Applied Polymer Science, 1978
- X‐ray diffraction orientation studies on blown polyethylene films. II. Measurements on films from a commercial blowing unitJournal of Applied Polymer Science, 1978
- X‐ray diffraction orientation studies on blown polyethylene films. I. Preliminary measurementsJournal of Applied Polymer Science, 1978
- Effects of molecular weight distribution and long‐chain branching on the viscoelastic properties of high‐ and low‐density polyethylene meltsJournal of Applied Polymer Science, 1978
- Influence of long‐chain branching on the viscoelastic properties of low‐density polyethylenesPolymer Engineering & Science, 1976
- Studies on Melt Spinning. I. Effect of Molecular Structure and Molecular Weight Distribution on Elongational ViscosityTransactions of the Society of Rheology, 1972
- New method for MWD determination in branched polymersJournal of Applied Polymer Science, 1971
- Effects of molecular weight distribution and branching on rheological properties of polyolefin meltsJournal of Applied Polymer Science, 1969