Reliability of agriculture universal joint shafts based on temperature measuring in universal joint bearing assemblies
Open Access
- 13 February 2015
- journal article
- Published by Instituto Nacional de Investigacion y Tecnologia Agraria y Alimentaria (INIA) in Spanish Journal of Agricultural Research
- Vol. 13 (1) , e0201
Abstract
This paper presents a research into reliability calculations of agriculture double universal joint shafts based on temperature measuring in cardan-type universal joint bearing assemblies. Special laboratory equipment was developed for this research which is presented in the paper. The objective of this research was to test the real life span of universal joint shafts in the laboratory and in field, to obtain the results which can be used to improve the reliability of universal joint shafts. If the presented research were used along with maintenance measures recommended in the paper and with proper use, the level of reliability of the shafts would be 2.1 times higher. The presented results of the research showed that needle bearings, i.e. bearing assemblies of the joints, are the most critical elements on universal joint shafts and are possible causes of their lower reliability. The second universal joint is the part with the lowest reliability in the observed technical system.Keywords
This publication has 5 references indexed in Scilit:
- Design and development of a chickpea stripper harvesterSpanish Journal of Agricultural Research, 2013
- Review. Advantages and disadvantages of control theories applied in greenhouse climate control systemsSpanish Journal of Agricultural Research, 2012
- Numerical and experimental aspects of thermally induced vibration in real rotorsThermal Science, 2011
- Investigation of the fracture of a car’s drive shaftEngineering Failure Analysis, 2009
- Two cases of failure in the power transmission system on vehicles: A universal joint yoke and a drive shaftEngineering Failure Analysis, 2007