Hydraulics of Skimming Flow on Modeled Stepped Spillways
- 1 May 1999
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 125 (5) , 500-510
Abstract
Two sets of models of stepped spillways of slope 1 upon 0.6 with the same crest-shape and with a range of step sizes (0.25–2.0 m on the 1:10 scale and 0.5–2.0 m on the 1:20 scale models) were built and studied. In the range of prototype unit flows considered (0.8–3.8 m2/s on the 1:10 scale models and 1.8–21.7 m2/s on the 1:20 models), the residual specific energy is independent of these step sizes, at positions where measurements were made on the spillways (from 30 m below the crest) once fully aerated skimming flow is established. The residual specific energy at the toe of a 50-m-high (or higher) stepped spillway, within the range of step heights tested, is <60% of the residual specific energy at the same level on a similar smooth spillway experiencing flows up to 20 m2/s; at these flows and at this height, the stepped spillway was found to be in equilibrium. The reduction of specific energy is lower than that expected from previous studies; these findings are likely to impact on the design of stepped sp...Keywords
This publication has 3 references indexed in Scilit:
- Hydraulics of skimming flows over stepped channels and spillwaysJournal of Hydraulic Research, 1994
- Skimming Flow in Stepped SpillwaysJournal of Hydraulic Engineering, 1990
- Stepped Spillway Hydraulic Model InvestigationJournal of Hydraulic Engineering, 1985