Uniaxial pulling and nano-scratching of a newly synthesized high entropy alloy
Open Access
- 1 November 2022
- journal article
- conference paper
- Published by AIP Publishing in APL Materials
- Vol. 10 (11) , 111118
Abstract
Multicomponent alloys possessing nanocrystalline structure, often alluded to as Cantor alloys or high entropy alloys (HEAs), continue to attract the great attention of the research community. It has been suggested that about 64 elements in the periodic table can be mixed in various compositions to synthesize as many as ∼108 different types of HEA alloys. Nanomechanics of HEAs combining experimental and atomic simulations are rather scarce in the literature, which was a major motivation behind this work. In this spirit, a novel high-entropy alloy (Ni25Cu18.75Fe25Co25Al6.25) was synthesized using the arc melting method, which followed a joint simulation and experimental effort to investigate dislocation-mediated plastic mechanisms leading to side flow, pileup, and crystal defects formed in the sub-surface of the HEA during and after the scratch process. The major types of crystal defects associated with the plastic deformation of the crystalline face-centered cubic structure of HEA were 2,3,4-hcp layered such as defect coordination structures, coherent ∑3 twin boundary, and ∑11 fault or tilt boundary, in combination with Stair rods, Hirth locks, Frank partials, and Lomer–Cottrell locks. Moreover, 1/6 Shockley, with exceptionally larger dislocation loops, was seen to be the transporter of stacking faults deeper into the substrate than the location of the applied cutting load. The (100) orientation showed the highest value for the kinetic coefficient of friction but the least amount of cutting stress and cutting temperature during HEA deformation, suggesting that this orientation is better than the other orientations for improved contact-mode manufacturing.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/T024607/1)
- Royal Society (NIF\R1\191571)
- Royal Academy of Engineering (TSP1332)
- European Metrology Program for Innovation and Research (A185, EMPIR)
- Engineering and Physical Sciences Research Council (EP/V055208/1)
This publication has 38 references indexed in Scilit:
- Atomsk: A tool for manipulating and converting atomic data filesComputer Physics Communications, 2015
- Influence of test methodology and probe geometry on nanoscale fatigue failure of diamond-like carbon filmSurface and Coatings Technology, 2014
- Microstructural development in equiatomic multicomponent alloysMaterials Science and Engineering: A, 2004
- Nanostructured High‐Entropy Alloys with Multiple Principal Elements: Novel Alloy Design Concepts and OutcomesAdvanced Engineering Materials, 2004
- Stacking fault energies and slip in nanocrystalline metalsNature Materials, 2004
- Misfit-energy-increasing dislocations in vapor-deposited CoFe/NiFe multilayersPhysical Review B, 2004
- Fast Parallel Algorithms for Short-Range Molecular DynamicsJournal of Computational Physics, 1995
- Dislocation nucleation from a crack tip: An analysis based on the Peierls conceptJournal of the Mechanics and Physics of Solids, 1992
- Intrinsic stacking faults in body-centred cubic crystalsPhilosophical Magazine, 1968
- Thermally activated motion of screw dislocations in B.C.C. metalsPhysica Status Solidi (b), 1966