Unbalanced Power Amplifier: An Architecture for Broadband Back-Off Efficiency Enhancement
- 21 August 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (2) , 367-381
Abstract
In this article, we present a new broadband power amplifier (PA) architecture with a back-off efficiency enhancement that supports very wide modulation bandwidths. The unbalanced PA is composed of two cooperating sub-PAs using the Lange couplers as input power splitter and output power combiner. The PA operation is controlled by the transistors' width ratio and coupling coefficients of the Lange couplers. The output power back-off (OPBO) level is given by the transistors' width ratio and coupling coefficient of the output coupler, while the maximum efficiency is achieved at the back-off point. These features provide more design flexibility compared with the conventional Doherty PA, where the OPBO can be set only by the transistors' width ratio, and the maximum efficiency is achieved at the peak power. Using broadband harmonic matching networks, the main and auxiliary sub-PAs operate in the continuous mode to improve efficiency over a broad bandwidth. A fully integrated unbalanced PA, implemented in a 250-nm GaN-on-SiC process, achieves 32.2-34.3-dBm output power, 27%-37% efficiency at peak power, and 27%-40% at 5-6-dB back-off, across 4.5-6.5 GHz. The PA provides 3.7/4.5% (-28.6/-26.9 dB) rms error vector magnitude (EVMrms) and 30% average efficiency for a 256-QAM signal with 100-/200-MHz bandwidth, 7.2-dB PAPR, and 25.5-dBm average output power, without using any predistortion.Keywords
Funding Information
- European Union’s Horizon 2020 research and innovation program under the Marie Sklodowska-Curie (713567)
- Science Foundation Ireland (13/RC/2077, 16/IA/4449)
This publication has 27 references indexed in Scilit:
- RF-Input Load Modulated Balanced Amplifier With Octave BandwidthIEEE Transactions on Microwave Theory and Techniques, 2017
- Voltage Mode Doherty Power AmplifierIEEE Journal of Solid-State Circuits, 2017
- A Novel 100 MHz–45 GHz Input-Termination-Less Distributed Amplifier Design With Low-Frequency Low-Noise and High Linearity Implemented With A 6 Inch $0.15~ {\mu }\text{m}$ GaN-SiC Wafer Process TechnologyIEEE Journal of Solid-State Circuits, 2016
- An Efficient Broadband Reconfigurable Power Amplifier Using Active Load ModulationIEEE Microwave and Wireless Components Letters, 2016
- ET Comes of Age: Envelope Tracking for Higher-Efficiency Power AmplifiersIEEE Microwave Magazine, 2016
- Broadband Sequential Power Amplifier With Doherty-Type Active Load ModulationIEEE Transactions on Microwave Theory and Techniques, 2015
- Asymmetric Broadband Doherty Power Amplifier Using GaN MMIC for Femto-Cell Base-StationIEEE Transactions on Microwave Theory and Techniques, 2015
- A GaN MMIC Modified Doherty PA With Large Bandwidth and Reconfigurable EfficiencyIEEE Transactions on Microwave Theory and Techniques, 2014
- A wideband Sequential Power Amplifier2014
- A Wideband and Compact GaN MMIC Doherty Amplifier for Microwave Link ApplicationsIEEE Transactions on Microwave Theory and Techniques, 2013