A Review of Two-Phase Forced Cooling in Three-Dimensional Stacked Electronics: Technology Integration
Authors:
- 25 September 2015
- journal article
- review article
- Published by ASME International in Journal of Electronic Packaging
- Vol. 137 (4) , 040802
Abstract
Three-dimensional (3D) stacked electronics present significant advantages from an electrical design perspective, ranging from shorter interconnect lengths to enabling heterogeneous integration. However, multitier stacking exacerbates an already difficult thermal problem. Localized hotspots within individual tiers can provide an additional challenge when the high heat flux region is buried within the stack. Numerous investigations have been launched in the previous decade seeking to develop cooling solutions that can be integrated within the 3D stack, allowing the cooling to scale with the number of tiers in the system. Two-phase cooling is of particular interest, because the associated reduced flow rates may allow reduction in pumping power, and the saturated temperature condition of the coolant may offer enhanced device temperature uniformity. This paper presents a review of the advances in two-phase forced cooling in the past decade, with a focus on the challenges of integrating the technology in high heat flux 3D systems. A holistic approach is applied, considering not only the thermal performance of standalone cooling strategies but also coolant selection, fluidic routing, packaging, and system reliability. Finally, a cohesive approach to thermal design of an evaporative cooling based heat sink developed by the authors is presented, taking into account all of the integration considerations discussed previously. The thermal design seeks to achieve the dissipation of very large (in excess of 500 W/cm2) background heat fluxes over a large 1 cm × 1 cm chip area, as well as extreme (in excess of 2 kW/cm2) hotspot heat fluxes over small 200 μm × 200 μm areas, employing a hybrid design strategy that combines a micropin–fin heat sink for background cooling as well as localized, ultrathin microgaps for hotspot cooling.Keywords
This publication has 57 references indexed in Scilit:
- Two-Phase Microchannel Heat Sinks: Theory, Applications, and LimitationsJournal of Electronic Packaging, 2011
- Hydraulic and thermal characteristics of a vapor venting two-phase microchannel heat exchangerInternational Journal of Heat and Mass Transfer, 2011
- Measurement and prediction of pressure drop in a two-phase micro-pin-fin heat sinkInternational Journal of Heat and Mass Transfer, 2009
- Fluid-to-Fluid Spot-to-Spreader (F2/S2) Hybrid Heat Sink for Integrated Chip-Level and Hot Spot-Level Thermal ManagementJournal of Electronic Packaging, 2009
- High heat flux flow boiling in silicon multi-microchannels – Part I: Heat transfer characteristics of refrigerant R236faInternational Journal of Heat and Mass Transfer, 2008
- High heat flux flow boiling in silicon multi-microchannels – Part II: Heat transfer characteristics of refrigerant R245faInternational Journal of Heat and Mass Transfer, 2008
- Effects of inlet/outlet configurations on flow boiling instability in parallel microchannelsInternational Journal of Heat and Mass Transfer, 2008
- Two-phase flow instability for boiling in a microchannel heat sinkInternational Journal of Heat and Mass Transfer, 2007
- Visualization and measurements of periodic boiling in silicon microchannelsInternational Journal of Heat and Mass Transfer, 2003
- Critical heat flux correlation for subcooled boiling flow in narrow channelsInternational Journal of Heat and Mass Transfer, 2002