A distributed MEMS gyro network for joint velocity estimation
Authors:
- 1 May 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1879-1884
Abstract
This paper is about improving joint and actuator velocity estimates on a human-sized hydraulic humanoid robot by adding a network of inexpensive microelectromechanical systems (MEMS) gyroscopes. Due to the lack of joint velocity sensors on the majority of humanoid robots, the joint velocity estimates often become a limiting factor on the controller performance. The distributed gyroscopes serve as indirect sensors of the joint velocities that can be estimated by a Kalman filter. Using this framework, we achieve higher velocity gains at the center of mass level on an Atlas hydraulic humanoid robot, which translates into better control performance.Keywords
This publication has 12 references indexed in Scilit:
- Inertial sensor-based humanoid joint state estimation2016
- Optimization based controller design and implementation for the Atlas robot in the DARPA Robotics Challenge Finals2015
- Simultaneous state and dynamics estimation in articulated structures2015
- Optimization based full body control for the atlas robot2014
- Decoupled state estimation for humanoids using full-body dynamics2014
- Geometry-aided angular acceleration sensing of rigid multi-body manipulator using MEMS rate gyros and linear accelerometers2013
- 3D walking based on online optimization2013
- Optimal State Estimation2006
- Detecting absolute human knee angle and angular velocity using accelerometers and rate gyroscopesMedical & Biological Engineering & Computing, 2001
- A discussion of the solution for the best rotation to relate two sets of vectorsActa Crystallographica Section A, 1978