High‐Strength Porous Alumina Ceramics by the Pulse Electric Current Sintering Technique
- 1 January 2002
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 85 (1) , 267-269
Abstract
High‐strength porous alumina has been fabricated with a microstructure control using the pulse electric current sintering (PECS) technique. During sintering the discharge, which is assumed to take place in the voids between the particles, is thought to promote the bridging of particles by neck growth in the initial stages of sintering, leaving high porosity. The effect of dopants (MgO, 200 ppm; TiO 2 , 1000 ppm) and of secondary inclusions (3 vol% 3Y‐TZP) on the constrained densification and the improvement in the mechanical behavior of porous alumina ceramics has been reported. The porosity of the fabricated porous alumina was controllable between 30% and 50% depending on the sintering temperature. The flexural strength of alumina having 30% and 42% porosity showed impressive values of 250 and 177 MPa, respectively. The dominance of the preferential neck growth of grains over densification significantly improved the mechanical properties of porous alumina, besides leaving high porosity.Keywords
This publication has 15 references indexed in Scilit:
- Bending strength and microstructure of Al2O3 ceramics densified by spark plasma sinteringJournal of the European Ceramic Society, 2000
- Preparation of Dense Mullite/Mo Composites by Pulse Electric Current Sintering (PECS) Technique2000
- Codoping of Alumina to Enhance Creep ResistanceJournal of the American Ceramic Society, 1999
- Porous Materials1998
- Effect of Porosity and Microstructure on the Strength of Si 3 N 4 : Designed Microstructure for High Strength, High Thermal Shock Resistance, and Facile MachiningJournal of the American Ceramic Society, 1997
- Strengthening of porous Al2O3 ceramics through nanoparticle additionNanostructured Materials, 1997
- Strength and Young's Modulus Behavior of a Partially Sintered Porous AluminaJournal of the American Ceramic Society, 1995
- Mechanical Properties of Partially Dense Alumina Produced from Powder CompactsJournal of the American Ceramic Society, 1994
- Hindrance of Grain Growth in Al 2 O 3 by ZrO 2 Inclusions.Journal of the American Ceramic Society, 1984
- Effect of TiO 2 on Initial Sintering of Al 2 O 3Journal of the American Ceramic Society, 1970