Effect of Film Position on the Flow and Heat Transfer Characteristics of Full-Ribbed Rotor Tip
Authors:
Open Access
- 22 February 2022
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Abstract
This article numerically studied the flow and heat transfer characteristics of the full-ribbed fluted tip of a rotor with four types of distribution of cooling films, namely, the mid-arc uniform film at the bottom of the groove, the uniform film on full perimeter ribs, the uniform film on the suction-side rib, and the uniform film on the pressure-side rib. The evolution of secondary flow in the tip clearance under these four conditions was discussed, and the effect of cooling film position on the tip leakage flow and tip heat transfer was also studied. The results showed that films in the ribs were more conducive to lower leakage flow rates and can reduce total energy losses. Adding cooling films on the single-side rib had a better effect on the control of leakage flow rate, with the most significant improvement due to adding cooling films on the suction-side rib. The mid-arc jet at the bottom of the groove can greatly contain the swirl structure in the groove, but it weakened the air sealing effect, which led to a rise in leak flow. The main reason for the swirl structure in the groove was that the leakage flow from the tip of the rotor was blocked by the cold air jet from the cooling films to form a backflow. The vortex inside the groove was the most violent when the air film hole was set on the pressure side, so the loss coefficient was higher, while the vortex inside the groove was the simplest when the cooling film hole was set on the suction side, and the energy loss caused by the vortex inside the groove was the least, and this structure was more favorable to the cooling of the leaf tip. It was also found that the uniformity of the outlet airflow angle distribution improved in the presence of cold air injection on the tip of the rotor.Keywords
This publication has 31 references indexed in Scilit:
- Effects of turbine blade tip shape on total pressure loss and secondary flow of a linear turbine cascadeInternational Journal of Heat and Fluid Flow, 2012
- Turbine Blade Tip Heat Transfer in Low Speed and High Speed FlowsJournal of Turbomachinery, 2011
- Influence of Stator-Rotor Interaction on the Aerothermal Performance of Recess Blade TipsJournal of Turbomachinery, 2010
- Tip gap height effects on flow structure and heat/mass transfer over plane tip of a high-turning turbine rotor bladeInternational Journal of Heat and Fluid Flow, 2009
- Film-Cooling Prediction on Turbine Blade Tip with Various Film Hole ConfigurationsJournal of Thermophysics and Heat Transfer, 2006
- Axial Turbine Blade Tips: Function, Design, and DurabilityJournal of Propulsion and Power, 2006
- Comparison of Turbine Tip Leakage Flow for Flat Tip and Squealer Tip Geometries at High-Speed ConditionsJournal of Turbomachinery, 2004
- Heat Transfer and Aerodynamics of Turbine Blade Tips in a Linear CascadeJournal of Turbomachinery, 2004
- Heat Transfer Coefficients and Film Cooling Effectiveness on the Squealer Tip of a Gas Turbine BladeJournal of Turbomachinery, 2003
- The Effect of Blade Tip Geometry on the Tip Leakage Flow in Axial Turbine CascadesJournal of Turbomachinery, 1992