Fracture resistance of 3-unit monolithic ZrO2 ceramics FPDs with different preparation designs of the distal abutment - an in-vitro study
Open Access
- 30 April 2023
- journal article
- research article
- Published by Pensoft Publishers in Folia Medica
- Vol. 65 (2) , 251-259
Abstract
Introduction: Masticatory pressure increases in the distal areas of the dentition. This should be considered when restoring partially edentulous patients with a metal-free fixed partial denture (FPD). An alternative abutment preparation design can be used in order to increase the materials’ volume in the most fracture-prone “connector area” of an FPD. The increased size of the connection might positively influence the constructions’ mechanical durability, thereby increasing its success and survivability.Aim: The aim of the present study was to investigate the influence of two preparation designs of the distal abutment on the fracture resistance of three-unit, monolithic, ZrO2 FPDs.Materials and methods: 3D printed replicas of a partially edentulous mandibular segment and a ZrO2, milled in full-contour, three-unit FPDs were used for this investigation. Two experimental groups (n=10 ) were defined based on the preparation design of the distal abutment tooth – classical shoulder preparation 0.8 mm deep, and endocrown preparation with a 2-mm retention cavity. The bridge – mandibular segment replica assembly was done with relyXU200(3M ESPE, USA), light-cured for 10 seconds per side with D-light Duo (GC, Europe). After cementation the test specimens were subjected to loading in a universal testing machine Zwick (Zwick-Roell Group, Germany). Statistical analysis was performed using R and includes descriptive statistics, t-test for quantitative and chi-squared test for qualitative variables.Results: The results showed no difference between the two studied groups in the maximum force required to fracture the test specimens [t=−1.8088 (17.39), p-value=0.087; P>0.05]. 95% of the fracture lines were located in the distal connector.Conclusions: Within the limitations of this study, it can be concluded that both tested preparation designs show similar results in terms of the load required to fracture the test specimens. Furthermore, it is confirmed that the distal connector is the weakest area of an all-ceramic 3-unit FPD in the posterior area.Keywords
This publication has 22 references indexed in Scilit:
- Translucency and flexural strength of translucent zirconia ceramicsThe Journal of Prosthetic Dentistry, 2023
- Strength and aging resistance of monolithic zirconia: an update to current knowledgeJapanese Dental Science Review, 2020
- Effects of two grading techniques of zirconia material on the fatigue limit of full-contour 3-unit fixed dental prosthesesDental Materials, 2017
- Effect of geometry on deformation of anterior implant-supported zirconia frameworks: An in vitro study using digital image correlationJournal of Prosthodontic Research, 2017
- An overview of monolithic zirconia in dentistryBiotechnology & Biotechnological Equipment, 2016
- Five-year clinical evaluation of zirconia-based bridges in patients in UK general dental practicesJournal of Dentistry, 2013
- Fatigue of zirconia and dental bridge geometry: Design implicationsDental Materials, 2010
- Comparison of survival and complication rates of tooth‐supported fixed dental prostheses (FDPs) and implant‐supported FDPs and single crowns (SCs)Clinical Oral Implants Research, 2007
- Fatigue of zirconia under cyclic loading in water and its implications for the design of dental bridgesDental Materials, 2007
- Contemporary all-ceramic fixed partial dentures: a reviewDental Clinics of North America, 2004