Geometric distortion-compensation via transient numerical simulation for directed energy deposition additive manufacturing
- 24 March 2020
- journal article
- research article
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 25 (6) , 468-475
Abstract
Components distort during directed energy deposition (DED) additive manufacturing (AM) due to the repeated localised heating. Changing the geometry in such a way that distortion causes it to assume the desired shape – a technique called distortion-compensation – is a promising method to reach geometrically accurate parts. Transient numerical simulation can be used to generate the compensated geometries and severely reduce the amount of necessary experimental trials. This publication demonstrates the simulation-based generation of a distortion-compensated DED build for an industrial-scale component. A transient thermo-mechanical approach is extended for large parts and the accuracy is demonstrated against 3d-scans. The calculated distortions are inverted to derive the compensated geometry and the distortions after a single compensation iteration are reduced by over 65%.Keywords
This publication has 16 references indexed in Scilit:
- Distortion prediction and compensation in selective laser meltingAdditive Manufacturing, 2017
- Dimensionless numbers in additive manufacturingJournal of Applied Physics, 2017
- Printability of alloys for additive manufacturingScientific Reports, 2016
- Welding Simulation in Car Body ConstructionPhotonicsViews, 2015
- Thermo-mechanical model development and validation of directed energy deposition additive manufacturing of Ti–6Al–4VAdditive Manufacturing, 2015
- Effect of inter-layer dwell time on distortion and residual stress in additive manufacturing of titanium and nickel alloysJournal of Materials Processing Technology, 2015
- Metal Additive Manufacturing: A ReviewJournal of Materials Engineering and Performance, 2014
- Effect of path planning on the laser powder deposition process: thermal and structural evaluationThe International Journal of Advanced Manufacturing Technology, 2010
- Investigations on residual stresses and deformations in selective laser meltingProduction Engineering, 2009
- Deformation modelling in layered manufacturing of metallic parts using gas metal arc welding: effect of process parametersModelling and Simulation in Materials Science and Engineering, 2005