A slew-rate controlled transmitter to compensate for the crosstalk-induced jitter of coupled microstrip lines
Authors:
- 1 September 2010
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 08865930,p. 1-4
Abstract
A single-ended transmitter eliminates the crosstalk-induced jitter at receiver by controlling the slew rates of the signal at transmitter for the even and odd modes of two parallel coupled microstrip lines. The transmitter chip in a 0.18 μm CMOS process reduces the total RX jitter by about 38 ps (53%) for the data rates from 2.6 to 5 Gbps, and increases the horizontal eye-opening (BER <; 1E-12) by about 21% at 5 Gbps.Keywords
This publication has 5 references indexed in Scilit:
- A 4 Gb/s 3-bit Parallel Transmitter With the Crosstalk-Induced Jitter Compensation Using TX Data Timing ControlIEEE Journal of Solid-State Circuits, 2009
- A 5-Gb/s/pin transceiver for DDR memory interface with a crosstalk suppression scheme2008
- FEXT Crosstalk Cancellation for High-Speed Serial Link Design2006
- Cancellation of Crosstalk-Induced JitterIEEE Journal of Solid-State Circuits, 2006
- Empirical equations on electrical parameters of coupled microstrip lines for crosstalk estimation in printed circuit boardIEEE Transactions on Advanced Packaging, 2001