Structural change induced inby swift heavy ions and its application to three-dimensional lithography
- 8 August 2003
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review B
- Vol. 68 (6) , 064106
Abstract
A rutile single crystal was irradiated by heavy ions with a high energy of the order of several tens of MeV. A good etching selectivity, where only the irradiated surface is well etched by hydrofluoric acid is induced by the irradiation. Through x-ray diffraction and high-resolution electron microscopy, it became clear that the irradiated region lost crystallization. It is considered that this amorphous region and the surrounding region are dissolved in hydrofluoric acid. Through the calculation of the ion energy, it was found that the etching always stopped at the depth where the electronic stopping power of the ion decayed to a critical value of 6.2 keV/nm, regardless of the ion species in the case of I, Br, Cu, and Ti ions. However, in the case of Ca ions with energies higher than about 72 MeV or Cl ions with energies higher than about 77 MeV, the irradiated top surface was not etched with hydrofluoric acid, but the inside surface several μm deep from the irradiated surface was etched. A calculation shows that the critical factor which determines whether the irradiated surface can be etched or not is the lateral energy density on the surface deposited by ions. The etched surface observed by atomic force microscopy is very smooth with a roughness of the order of nm. Therefore, a combination of ion irradiation and etching can be used as a novel fabrication method of nanostructures in rutile.
Keywords
This publication has 34 references indexed in Scilit:
- Manufacturing method for transparent electric windows using dye-sensitized TiO2 solar cellsSolar Energy Materials and Solar Cells, 2003
- Influence of neutron irradiation and its post-annealing on optical absorption of rutileNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2002
- Erbium-activated silica–titania planar waveguides on silica-on-silicon substrates prepared by rf sputteringJournal of Non-Crystalline Solids, 2001
- Analysis of SiO2/TiO2–SiO2/SiO2 coupled parallel waveguide structures using computer aided design techniquesOptics Communications, 2000
- The optical waveguiding properties of TiO2–SiO2 composite films prepared by the sol–gel processCeramics International, 1999
- Optical gain in Er-doped SiO2–TiO2 waveguides fabricated by the sol–gel techniqueOptics Communications, 1999
- On the synthesis of nanostructured TiO2 anatase phase and the development of the photoelectrochemical solar cellInternational Journal of Hydrogen Energy, 1999
- 3D Metallo-Dielectric Photonic Crystals with Strong Capacitive Coupling between Metallic IslandsPhysical Review Letters, 1998
- An overview of semiconductor photocatalysisJournal of Photochemistry and Photobiology A: Chemistry, 1997
- Electrochemical Photolysis of Water at a Semiconductor ElectrodeNature, 1972