Suggested Modifications of the ASTM D2344-16 Short-Beam Shear Test Method to Be Applied to Fiber Metal Laminates
- 24 June 2019
- journal article
- research article
- Published by ASTM International in Journal of Testing and Evaluation
- Vol. 49 (2) , 1213-1221
Abstract
ASTM D2344/D2344M-16, Standard Test Method for Short-Beam Strength of Polymer Matrix Composite Materials and Their Laminates, is used to test fiber-metal laminates (FMLs), although its scope is limited to high-modulus fiber-reinforced composite materials. These two groups of materials have differences in their mechanical behavior, and it is possible that this standard cannot be employed in FMLs in its current status. To verify this, short-beam shear (SBS) tests were performed in aramid aluminum laminate (ARALL) 3 4/3 specimens employing two sets of rollers diameters. One set was in accordance with ASTM D2344/D2344M-16, whereas the other made use of smaller diameters. The options to stop the tests presented in the standard were not adequate for the ARALL specimens using the normalized rollers diameters. Modifications to the standard in order to include FML specimens are suggested as follows: to include a test rig with reduced roller diameters, to observe of delamination at one side of a specimen as a new option to stop the test, and to define the short-beam strengths (Fsbs) as that corresponding to the maximum load value observed previous to a total load drop-off of 30 %. The difference between the means of Fsbs obtained with both set of rollers was not significant when using these modifications.Keywords
This publication has 13 references indexed in Scilit:
- Short‐beam Shear Method for Assessment of Stress–Strain Curves for Fibre‐reinforced Polymer Matrix Composite MaterialsStrain, 2013
- A review: Fibre metal laminates, background, bonding types and applied test methodsMaterials & Design (1980-2015), 2011
- The effects of void contents on the long-term hygrothermal behaviors of glass/epoxy and GLARE laminatesComposite Structures, 2010
- A comparative study on the properties of GLARE laminates cured by autoclave and autoclave consolidation followed by oven postcuringThe International Journal of Advanced Manufacturing Technology, 2009
- Hygrotermal effects evaluation using the iosipescu shear test for glare laminatesJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2008
- Analytical prediction model for fatigue crack propagation and delamination growth in GlareInternational Journal of Fatigue, 2007
- A review on the development and properties of continuous fiber/epoxy/aluminum hybrid composites for aircraft structuresMaterials Research, 2006
- The effect of adhesive bonding between aluminum and composite prepreg on the mechanical properties of carbon-fiber-reinforced metal laminatesComposites Science and Technology, 1997
- Experimental Study of Three- and Four-Point Shear Test SpecimensJournal of Composites Technology and Research, 1995
- On short-beam shear tests for composite materialsExperimental Mechanics, 1985