BROADBAND SIGNAL SIMULATION IN SHALLOW WATER
Authors:
- 1 December 2003
- journal article
- research article
- Published by World Scientific Pub Co Pte Ltd in Journal of Computational Acoustics
- Vol. 11 (04) , 577-591
Abstract
Today's minimum requirements for ocean acoustic models are to be able to simulate broadband signal transmissions in 2D varying environments with an acceptable computational effort. Standard approaches comprise ray, normal mode and parabolic equation techniques. In this paper we compare the performance of four broadband models [ ] on a set of shallow-water test environments with propagation out to 10 km and a maximum signal bandwidth of 10–1000 Hz. It is shown that a computationally efficient modal approach as implemented in the [ ] model is much faster than standard, less optimized models such as [ ] and [ ]. However, the handling of range dependency in the adiabatic approximation is not always sufficiently accurate, and it is suggested that a mode coupling approach be adopted in [ ]. Moreover, the interpolation of modal properties in range could lead to a further significant speed-up of mode calculations in range-dependent environments. It is concluded that coupled modes with wavenumber interpolation in both frequency and range remain the most promising wave modeling approach for broadband signal simulations in range-dependent shallow water environments. At higher frequencies (> 1 kHz) there is currently no alternative to rays as a practical signal simulation tool.Keywords
This publication has 3 references indexed in Scilit:
- A normal mode model for acousto-elastic ocean environmentsThe Journal of the Acoustical Society of America, 1996
- Gaussian ray bundles for modeling high-frequency propagation loss under shallow-water conditionsThe Journal of the Acoustical Society of America, 1996
- A split-step Padé solution for the parabolic equation methodThe Journal of the Acoustical Society of America, 1993