Pressure–Impulse (P–I) Diagrams for Reinforced Concrete (RC) Structures: A Review
- 13 February 2018
- journal article
- review article
- Published by Springer Nature in Archives of Computational Methods in Engineering
- Vol. 26 (3) , 733-767
Abstract
No abstract availableKeywords
This publication has 94 references indexed in Scilit:
- Simulation of Retrofitted Unreinforced Concrete Masonry Unit Walls under Blast LoadingInternational Journal of Protective Structures, 2013
- Development of P-I diagrams for FRP strengthened RC columnsInternational Journal of Impact Engineering, 2011
- What to look for in the aftermath of an explosion? A review of blast scene damage observablesEngineering Failure Analysis, 2011
- Retrofit strategies to protect structures from blast loadingThis article is one of a selection of papers published in the Special Issue on Blast Engineering.Canadian Journal of Civil Engineering, 2009
- Pressure–impulse diagrams for the behavior assessment of structural componentsInternational Journal of Impact Engineering, 2008
- P–I diagram method for combined failure modes of rigid-plastic beamsInternational Journal of Impact Engineering, 2007
- Numerical simulation of structural response and damage to simultaneous ground shock and airblast loadsInternational Journal of Impact Engineering, 2007
- Pulse loading shape effects on pressure–impulse diagram of an elastic–plastic, single-degree-of-freedom structural modelInternational Journal of Mechanical Sciences, 2002
- The deformation and tearing of thin square plates subjected to impulsive loads—An experimental studyInternational Journal of Impact Engineering, 1996
- Correlation Parameters for Eliminating the Effect of Pulse Shape on Dynamic Plastic DeformationJournal of Applied Mechanics, 1970