Effect of sodium thiazolinyl dithiopropane sulphonate (SH110) addition on electroplating nanotwinned copper films and their filling performance of fine-pitch redistributed layer (RDL)
- 20 October 2022
- journal article
- research article
- Published by IOP Publishing in Nanotechnology
- Vol. 34 (1) , 015710
Abstract
Nanotwinned copper is a potential microelectronic interconnection material due to its superior strength and conductivity, however, its filling ability is urgently needed to improve before its application in the field of advanced packaging. The effect of additive (sodium thiazolinyl dithiopropane sulphonate, SH110) addition on the surface roughness, microstructure, mechanical properties and filling capacity of nanotwinned copper films was investigated. The surface roughness and grain size were firstly reduced then increased with the increasing concentrations of SH110, reaching the minimum value at 10 ppm. It was noticed that copper films with 10 ppm SH110 also possessed superior tensile strength and elongation, which were measured as 481 MPa and 3.68% on average of 12 μm thick samples by dynamic thermo-mechanical analyzer. Further, their uniformity and flatness of redistributed layers (RDLs) were controlled as 2% and 1.9%, which were significantly improved compared to the samples without SH110 (7.6% and 4.7%). As demonstrated by linear sweep voltammetry analysis and galvanostatic measurement, the SH110 could cooperate well with gelatin and serve as a combination of accelerator and leveler, resulting in the improvement of filling capacity for nanotwinned copper RDLs.Keywords
Funding Information
- National Natural Science Foundation of China (62104243)
- Guangdong Basic and Applied Basic Research Foundation (2022A1515011485 & 2019A1515110771)
- SIAT Innovation Program for Excellent Young Researchers
This publication has 24 references indexed in Scilit:
- Electrodeposition and growth mechanism of preferentially orientated nanotwinned Cu on silicon wafer substrateJournal of Materials Science & Technology, 2018
- The diffusion barrier effect of Fe-Ni UBM as compared to the commercial Cu UBM during high temperature storageJournal of Alloys and Compounds, 2018
- Bottom–Up Electrodeposition of Large-Scale Nanotwinned Copper within 3D Through Silicon ViaMaterials, 2018
- Void-free and high-speed filling of through ceramic holes by copper electroplatingMicroelectronics Reliability, 2017
- Microstructure of Electrodeposited Cu Micro-cylinders in High-Aspect-Ratio Blind Holes and Crystallographic Texture of the Cu Overburden FilmJournal of Materials Science & Technology, 2016
- Plating Uniformity of Bottom-up Copper Pillars and Patterns for IC Substrates with Additive-assisted ElectrodepositionElectrochimica Acta, 2014
- Microstructure control of unidirectional growth of η-Cu6Sn5 in microbumps on 〈1 1 1〉 oriented and nanotwinned CuActa Materialia, 2013
- Eliminate Kirkendall voids in solder reactions on nanotwinned copperScripta Materialia, 2013
- Unidirectional Growth of Microbumps on (111)-Oriented and Nanotwinned CopperScience, 2012
- Ultrahigh Strength and High Electrical Conductivity in CopperScience, 2004