Effect of thick DLC coating on fatigue behaviour of magnesium alloy in laboratory air and demineralised water
Authors:
- 3 August 2010
- journal article
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 33 (9) , 607-616
Abstract
Rotating bending fatigue tests have been performed using Diamond‐like carbon (DLC) coated specimens of a wrought magnesium alloy, AZ80A, in laboratory air and demineralised water and the effect of DLC coating on fatigue and corrosion fatigue behaviour was studied. Three film thicknesses of 3.5 μm, 13 μm, and 25 μm (two‐layer film) were evaluated and particular attention was paid to the role of thick DLC coating. In laboratory air, the fatigue strengths of the DLC‐coated specimens were higher than that of the substrate specimen and increased with increasing film thickness. This was because hard DLC coating with good adhesion suppressed the crack initiation due to cracking of inclusions or cyclic slip deformation on the substrate surface. In demineralised water, the fatigue strength of the 3.5‐μm DLC‐coated specimen was the same as that of the substrate specimen due to the penetration of the water through pre‐existing film defects, while the 13‐μm and 25‐μm DLC‐coated specimens showed increased corrosion fatigue strength with increasing film thickness and also exhibited nearly the same fatigue strength as in laboratory air except for a few premature failed specimens, indicating a potential of thick DLC coating or two‐layer coating for complete improvement of corrosion fatigue strength in aqueous environments.Keywords
This publication has 16 references indexed in Scilit:
- Thick DLC films deposited by PECVD on the internal surface of cylindrical substratesDiamond and Related Materials, 2008
- Fatigue Properties of DLC-Coated Ti-6Al-4V AlloyTRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 2008
- Friction properties of protective DLC films on magnesium alloy in aqueous NaCl solutionNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2007
- Diamond like carbon film as a protective coating for high strength steel and titanium alloySurface and Coatings Technology, 2006
- Effect of extrusion conditions on grain refinement and fatigue behaviour in magnesium alloysMaterials Science and Engineering: A, 2006
- Friction and wear of DLC films on magnesium alloySurface and Coatings Technology, 2005
- Fatigue properties of Keronite® coatings on a magnesium alloySurface and Coatings Technology, 2004
- Electrochemical corrosion behaviour of uncoated and DLC coated medical grade Co28Cr6MoSurface and Coatings Technology, 2004
- Influence of anodization on the fatigue life of WE43A-T6 magnesiumScripta Materialia, 1999
- Analysis of stress intensity factors for surface cracks subjected to arbitrarily distributed surface stresses. (3rd report Analysis and application of influence coefficients for round bars with a semielliptical surface crack)TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A, 1987