Measurement of flash temperature and contact between slider and magnetic recording disk
Authors:
- F.E. KennedyFKF.E. Kennedy
- 1 September 1989
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 25 (5) , 3728-3730
Abstract
Flash temperatures and contact events were measured during tests of a low flying slider and rigid thin-film magnetic disks. The Al/sub 2/O/sub 3/-TiC slider had iron-constantan thermocouples embedded in its rails. The thermocouples served as both temperature sensors and electrically conductive contact probes. The flash temperature was determined to be about 150 degrees C during the impact of a single asperity and the slider. The impact load was found to be slightly less than 1 N. This value is slightly smaller than the force predicted by a theory based on slider inertia and indentation hardness. Contact event measurements disclosed that asperities on the disk surface deform plastically, even during the low-speed sliding encountered in contact start/stop cycles. The plastic deformation diminishes the severity of contact between head and disk in subsequent start/stop cycles.Keywords
This publication has 4 references indexed in Scilit:
- Magnetic Head-Media Interface Temperatures: Part 1—AnalysisJournal of Tribology, 1987
- Possible Flash Temperatures in Slider and Recording Disk Transient ContactA S L E Transactions, 1986
- Transition from Boundary Lubrication to Hydrodynamic Lubrication of Slider BearingsIBM Journal of Research and Development, 1974
- The temperature of rubbing surfacesWear, 1959