Development of Ceramic Cutting Tools for Future Application on Dry Machining
- 1 October 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 660-661, 724-729
Abstract
Advanced ceramic materials constitute a mature technology with a very broad base of current and potential applications and a growing list of material compositions. Within the advanced ceramics category, silicon nitride based ceramics are wear-resistant, corrosion- resistant and lightweight materials, and are superior to many materials with regard to stability in high-temperature environments. Because of this combination the silicon nitride ceramics have an especially high potential to resolve a wide number of machining problems in the industries. Presently the Si3N4 ceramic cutting tool inserts are developed using additives powders that are pressed and sintered in the form of a cutting tool insert at a temperature of 1850 oC using pressureless sintering. The microstructure of the material was observed and analyzed using XRD, SEM, and the mechanical response of this array microstructure was characterized for hardness Vickers and fracture toughness. The results show that Si3N4/20 wt.% (AlN and Y2O3) gives the best balance between hardness Vickers and fracture toughness. The Si3N4/15 wt.% (AlN and Y2O3) composition allows the production of a very fine-grained microstructure with low decreasing of the fracture toughness and increased hardness Vickers. These ceramic cutting tools present adequate characteristics for future application on dry machining.Keywords
This publication has 18 references indexed in Scilit:
- α-SiAlON: Development and Machining Test on Gray Cast IronMaterials Science Forum, 2008
- SiAlON based ceramic cutting toolsJournal of the European Ceramic Society, 2008
- Self-lubricating behaviors of Al2O3/TiB2 ceramic tools in dry high-speed machining of hardened steelJournal of the European Ceramic Society, 2005
- α-SiAlON ceramics with elongated grain morphology using an alternative sintering additiveMaterials Letters, 2004
- Investigations on hard turning with minimal cutting fluid application (HTMF) and its comparison with dry and wet turningInternational Journal of Machine Tools and Manufacture, 2002
- Wear characteristics in turning high hardness alloy steel by ceramic and CBN toolsJournal of Materials Processing Technology, 1999
- Environmentally clean metal cutting processes—machining on the way to dry cuttingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 1999
- Development of alumina and Ce-TTZ ceramic-ceramic composite (ZTA) cutting toolInternational Journal of Refractory Metals and Hard Materials, 1995
- Wear Behaviour of Ceramic Cutting-ToolsKey Engineering Materials, 1994
- Microstructural Development, Microstructural Characterization and Relation to Mechanical Properties of Dense Silicon Nitride1986