Fatigue of high impact polystyrene and influence of surface treatments
Authors:
- 1 October 1981
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 52 (10) , 5970-5976
Abstract
The fatigue endurance of unnotched samples of a rubber modified, high impact polystyrene (HIPS) was determined under tension-compression cycling. The role of the rubber phase inclusions in the fatigue fracture process was further studied by detailed examination of the fracture surfaces by optical methods and by scanning electron microscopy. The observed morphology is compared with that obtained on HIPS samples subject to simple tension bonding and with that obtained on the unmodified polystyrene homopolymer. The dispersed rubber phase particles lead to an increased fatigue crack propagation resistance and, if comparison is made on the basis of the same relative stress, the rubber modified polymer leads also to increased fatigue lifetimes. The influence of various environmental variables such as elevated temperature annealing, surface condition, and surface treatments is discussed. Silicon oil coatings of low viscosity tend to significantly reduce fatigue lifetimes, but lifetimes increase with increased viscosity of oil coating. Significant enhancement in fatigue endurance can be realized by use of elastomeric coatings, such as a thin layer of nitrile rubber.Keywords
This publication has 13 references indexed in Scilit:
- Craze and fatigue resistance of glassy polymersJournal of Macromolecular Science, Part B, 1981
- Fatigue characteristics of high impact polystyrenePolymer, 1981
- Fatigue of polymersInternational Journal of Fracture, 1980
- Effects of environment and surface coatings on the fatigue properties of polystyrenePolymer, 1978
- Effects of environment on the mechanical properties of plastics under high pressurePolymer Engineering & Science, 1978
- The effect of rubber particle size on the mechanical properties of high-impact polystyreneJournal of Applied Polymer Science, 1978
- Influence of molecular weight on fatigue behavior of polyethylene and polystyrenePolymer Engineering & Science, 1977
- The Provision of Toughness in One and Two Phase PolymersPure and Applied Chemistry, 1976
- The environmental stress-crazing and cracking in polystyrene under high pressureJournal of Macromolecular Science, Part B, 1975
- Fracture of high‐impact polystyrene under fatigue loadingJournal of Polymer Science: Polymer Physics Edition, 1973