Effect of Hydrogen Exposure on Mechanical and Tribological Behavior of CrxN Coatings Deposited at Different Pressures on IN718
Open Access
Abstract
In the current study, the properties of the CrxN coatings deposited on the Inconel 718 superalloy using direct current reactive magnetron sputtering are investigated. The influence of working pressure on the microstructure, mechanical, and tribological properties of the CrxN coatings before and after high-temperature hydrogen exposure is studied. The cross-sectional scanning electron micrographs indicate the columnar structure of the coatings, which changes from dense and compact columns to large columns with increasing working pressure. The Cr/N ratio increases from 1.4 to 1.9 with increasing working pressure from 300 to 900 mPa, respectively. X-ray diffraction analysis reveals a change from mixed hcp-Cr2N and fcc-CrN structure to approximately stoichiometric Cr2N phase. After gas-phase hydrogenation, the coating deposited at 300 mPa exhibits the lowest hydrogen absorption at 600 °C of all investigated coatings. The results indicate that the dense mixed cubic and hexagonal structure is preferential for hydrogen permeation resistance due to the presence of cubic phase with higher packing density in comparison to the hexagonal structure. After hydrogenation, no changes in phase composition were observed; however, a small amount of hydrogen is accumulated in the coatings. An increase of coating hardness and elastic modulus was observed after hydrogen exposure. Tribological tests reveal that hydrogenation leads to a decrease of the friction coefficient up to 20%–30%. The best value of 0.25 was reached for hydrogen exposed CrxN coating deposited at 300 mPa.Keywords
This publication has 49 references indexed in Scilit:
- Microstructure and tribological behavior of multilayered CrN coating by arc ion platingSurface and Coatings Technology, 2015
- Failure and deformation mechanisms during indentation in nanostructured Cr/CrN multilayer coatingsSurface and Coatings Technology, 2014
- Influence of niobium ion implantation on the microstructure, mechanical and tribological properties of TiAlN/CrN nano-multilayer coatingsSurface and Coatings Technology, 2014
- Effect of substrate bias voltage on the properties of CrCN and CrN coatings deposited by cathodic arc evaporationVacuum, 2013
- Anti-wear multilayer coatings based on chromium nitride for wood machining toolsWear, 2010
- Crystallographic aspects related to advanced tribological multilayers of Cr/CrN and Ti/TiN types produced by pulsed laser deposition (PLD)Surface and Coatings Technology, 2006
- Growth phenomena in room temperature pulsed laser deposited chromium and chromium nitride coatingsSurface and Coatings Technology, 2005
- Friction and wear properties of CrAlN and CrVN films deposited by cathodic arc ion plating methodSurface and Coatings Technology, 2004
- Compositional characterization of CrN films deposited by ion beam-assisted deposition process on stainless steelThin Solid Films, 2001
- Young's modulus and stress of CrN deposited by cathodic vacuum arc evaporationSurface and Coatings Technology, 1994