Piles for offshore wind turbines: a state-of-the-art review
Authors:
- 1 August 2011
- journal article
- Published by Emerald Publishing in Proceedings of the Institution of Civil Engineers - Geotechnical Engineering
- Vol. 164 (4) , 245-256
Abstract
The paper considers the current state of the art for estimating the pull-out capacity of driven open-ended piles used to support wind turbine foundations founded on sand. The latest edition of the American Petroleum Institute guidelines for pile design includes a conventional earth pressure approach and four alternative cone penetration test (CPT) methods for estimating pile shaft resistance in sand. A database of open-ended pile tests was used to assess the predictive reliability of the design approaches. While the earth pressure approach was unreliable, exhibiting bias with pile slenderness and sand relative density, the CPT methods were shown to provide improved and relatively consistent estimates of pile capacity. However, the tension loads experienced by wind turbine foundations are significantly higher than those applied to piles in the database. When the CPT methods were used to estimate the pile length required to support a 5 MW turbine installed in typical offshore soil conditions, the CPT methods provided a wide range of predicted pile lengths. The reasons for this divergence are discussed and an alternative framework for considering driven pile shaft resistance is put forward.Keywords
This publication has 15 references indexed in Scilit:
- Database Assessment of CPT-Based Design Methods for Axial Capacity of Driven Piles in Siliceous SandsJournal of Geotechnical and Geoenvironmental Engineering, 2008
- Effect of Friction Fatigue on Pile Capacity in Dense SandJournal of Geotechnical and Geoenvironmental Engineering, 2007
- Some observations of the effects of time on the capacity of piles driven in sandGéotechnique, 2006
- Axial load tests on pipe piles in very dense sands at Ras Tanajib2005
- Friction fatigue on displacement piles in sandGéotechnique, 2004
- Displacement and strain paths during plane-strain model pile installation in sandGéotechnique, 2004
- Science and empiricism in pile foundation designGéotechnique, 2003
- Estimation of Load Capacity of Pipe Piles in Sand Based on Cone Penetration Test ResultsJournal of Geotechnical and Geoenvironmental Engineering, 2003
- The shaft capacity of pipe piles in sandCanadian Geotechnical Journal, 2003
- Base Resistance of Jacked Pipe Piles in SandJournal of Geotechnical and Geoenvironmental Engineering, 2001