Predicting the Effect of Hull Roughness on Ship Resistance Using a Fully Turbulent Flow Channel
Open Access
- 2 December 2022
- journal article
- research article
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 10 (12) , 1863
Abstract
The consequences of poor hull surface conditions on fuel consumption and emissions are well-known. However, their rationales are yet to be thoroughly understood. The present study investigates the hydrodynamics of fouling control coatings and mimicked biofouling. Novel experimental roughness function data were developed from the “young” fully turbulent flow channel facility of the University of Strathclyde. Different surfaces, including a novel hard foul-release coating, were tested. Finally, the performance of a benchmark full-scale containership was predicted using Granville’s similarity law scaling calculations. Interestingly, the numerical predictions showed that the novel hard foul-release coating tested had better hydrodynamic performance than the smooth case. A maximum 3.79% decrease in the effective power requirements was observed. Eventually, the results confirmed the practicality of flow channel experiments in combination with numerical-based methods to investigate hull roughness effects on ship resistance and powering. The present study can also serve as a valuable guide for future experimental campaigns using the fully turbulent flow channel facility of the University of Strathclyde.Keywords
Funding Information
- EU H2020 project, VENTuRE (856887, 20200615)
- Inha University (856887, 20200615)
- Development of Autonomous Ship Technology (856887, 20200615)
- the Ministry of Oceans and Fisheries (MOF, Republic of Korea) (856887, 20200615)
This publication has 29 references indexed in Scilit:
- Economic impact of biofouling on a naval surface shipBiofouling, 2010
- Refined c
f
relation for turbulent channels and consequences for high- Re experimentsFluid Dynamics Research, 2009
- Effects of coating roughness and biofouling on ship resistance and poweringBiofouling, 2007
- The rough-wall turbulent boundary layer from the hydraulically smooth to the fully rough regimeJournal of Fluid Mechanics, 2007
- A review of surface roughness in antifouling coatings illustrating the importance of cutoff lengthBiofouling, 2006
- Frictional Resistance of Antifouling Coating SystemsJournal of Fluids Engineering, 2004
- Measurement of flows around modern commercial ship modelsExperiments in Fluids, 2001
- Engineering application of experimental uncertainty analysisAIAA Journal, 1995
- Reynolds Number Dependence of Skin Friction and Other Bulk Flow Variables in Two-Dimensional Rectangular Duct FlowJournal of Fluids Engineering, 1978
- A NEW THEORY OF TURBULENT FLOW IN LIQUIDS OF SMALL VISCOSITY. (IN ABSTRACT FORM).Journal of the Institution of Civil Engineers, 1939