Fabrication, Structure, and Thermal Properties of Mg–Cu Alloys as High Temperature PCM for Thermal Energy Storage
Open Access
Abstract
This work studied the thermophysical properties of Mg-24%Cu, Mg-31%Cu, and Mg-45%Cu (wt.%) alloys to comprehensively consider the possibility of using them as thermal energy storage (TES) phase change materials (PCMs) used at high temperatures. The microstructure, phase composition, phase change temperatures, and enthalpy of these alloys were investigated by an electron probe micro analyzer (EPMA), X-ray diffraction (XRD), and differential scanning calorimetry (DSC). The XRD and EPMA results indicated that the binary eutectic phase composed of α-Mg and Mg2Cu exists in the microstructure of the prepared Mg–Cu series alloys. The microstructure of Mg-24%Cu and Mg-31%Cu is composed of α-Mg matrix and binary eutectic phases, and Mg-45%Cu is composed of primary Mg2Cu and binary eutectic phases. The number of eutectic phases is largest in Mg-31%Cu alloy. The DSC curves indicated that the onset melting temperature of Mg-24%Cu, Mg-31%Cu, and Mg-45%Cu alloys were 485, 486, and 485 °C, and the melting enthalpies were 152, 215, and 91 J/g. Thermal expansion and thermal conductivity were also determined, revealing that the Mg–Cu alloys had a low linear thermal expansion coefficient and high thermal conductivity with respect to increasing temperatures. In conclusion, the thermal properties demonstrated that the Mg–Cu alloys can be considered as a potential PCM for TES.Keywords
Funding Information
- Department of Science and Technology of Hubei Province (2021BGE023, 2020BED002)
This publication has 26 references indexed in Scilit:
- Miscibility gap alloys with inverse microstructures and high thermal conductivity for high energy density thermal storage applicationsApplied Thermal Engineering, 2013
- Selection of materials for high temperature latent heat energy storageSolar Energy Materials and Solar Cells, 2012
- Review on storage materials and thermal performance enhancement techniques for high temperature phase change thermal storage systemsRenewable and Sustainable Energy Reviews, 2012
- Numerical heat transfer analysis of the packed bed latent heat storage system based on an effective packed bed modelEnergy, 2010
- State of the art on high-temperature thermal energy storage for power generation. Part 2—Case studiesRenewable and Sustainable Energy Reviews, 2010
- Review on thermal energy storage with phase change materials and applicationsRenewable and Sustainable Energy Reviews, 2009
- Exergy recovery from steelmaking off-gas by latent heat storage for methanol productionEnergy, 2006
- Screening of high melting point phase change materials (PCM) in solar thermal concentrating technology based on CLFRSolar Energy, 2005
- A review on phase change energy storage: materials and applicationsEnergy Conversion and Management, 2004
- Heat storage in eutectic alloysMetallurgical Transactions A, 1980