Properties of solid solutions of poly(ethylene oxide)/epoxidized natural rubber blends and LiClO4
Authors:
- 9 July 2008
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 110 (1) , 424-432
Abstract
Solid solutions of blends of poly(ethylene oxide) (PEO) and epoxidized natural rubber (ENR) comprising 12 wt % of LiClO4 were studied. Two glass transition temperatures, corresponding to the Tgs of the constituents, confirm immiscibility of the polymers over the entire composition range. It turns out that the Tgs of both polymers slightly increase after addition of salt to the blends. This shift is approximately constant over the whole range of blend composition. Accordingly, Tg measurements reveal that the salt dissolves to approximately equal relative amounts in the two phases. The degree of crystallinity of PEO in blends with ENR descends only to a minor extent with ENR content. However, addition of salt leads first to decreasing crystallinity and second this decrease becomes more pronounced with the addition of ENR. It shows that under these experimental conditions the salt content in PEO increases as compared to ENR. As one expects, the rate of isothermal crystallization does not change in blends as long as PEO is in excess. The situation changes again when salt is added. The rate decreases in a certain range of crystallization temperatures when ENR is added, demonstrating that salt is favorably dissolved in PEO. Conductivity was measured in polymers comprising different salt concentrations. A power‐law dependence of conductivity on salt concentration was found. It results that the mobility of charge carriers in PEO exceeds that of ENR by five orders of magnitude. Therefore, the conductivity in blends is primarily governed by PEO as long as PEO is in excess. Conductivity measurements reveal again that salt is preferably dissolved in PEO. The distribution coefficient is estimated. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008Keywords
This publication has 12 references indexed in Scilit:
- ac impedance, DSC and FT-IR investigations on (x)PVAc–(1−x)PVdF blends with LiClO4Materials Chemistry and Physics, 2006
- Crystallization and melting behavior of blends comprising poly(3‐hydroxy butyrate‐co‐3‐hydroxy valerate) and poly(ethylene oxide)Journal of Applied Polymer Science, 2006
- Dual-phase polymer electrolyte with enhanced phase compatibility based on Poly(MMA-g-PVC)/PMMAEuropean Polymer Journal, 2006
- Solid electrolyte membranes from semi-interpenetrating polymer networks of PEG-grafted polymethacrylates and poly(methyl methacrylate)Solid State Ionics, 2006
- Viscometry and Light Scattering of Polymer Blend Solutions2005
- Crystallization and Melting Behavior of Poly(3‐hydroxybutyrate)‐Based BlendsMacromolecular Chemistry and Physics, 2004
- Theoretical consideration on phase behaviors of poly(ethylene oxide-block-propylene oxide)/LiCF3SO3 systems in lithium batteryElectrochimica Acta, 2004
- Polymer electrolytes based on modified natural rubberSolid State Ionics, 2002
- Complexes of alkali metal ions with poly(ethylene oxide)Polymer, 1973
- Melting process and the equilibrium melting temperature of polychlorotrifluoroethyleneJournal of Research of the National Bureau of Standards Section A: Physics and Chemistry, 1962