Flat ion milling: a powerful tool for preparation of cross-sections of lead-silver alloys
- 16 November 2012
- journal article
- research article
- Published by Oxford University Press (OUP) in Microscopy
- Vol. 62 (3) , 411-418
Abstract
While conventional mechanical and chemical polishing results in stress, deformation and polishing particles embedded on the surface, flat milling with Ar+ ions erodes the material with no mechanical artefacts. This flat milling process is presented as an alternative method to prepare a Pb–Ag alloy cross-section for scanning electron microscopy. The resulting surface is free of scratches with very little to no stress induced, so that electron diffraction and channelling contrast are possible. The results have shown that energy dispersive spectrometer (EDS) mapping, electron channelling contrast imaging and electron backscatter diffraction can be conducted with only one sample preparation step. Electron diffraction patterns acquired at 5 keV possessed very good pattern quality, highlighting an excellent surface condition. An orientation map was acquired at 20 keV with an indexing rate of 90.1%. An EDS map was performed at 5 keV, and Pb–Ag precipitates of sizes lower than 100 nm were observed. However, the drawback of the method is the generation of a noticeable surface topography resulting from the interaction of the ion beam with a polycrystalline and biphasic sample.Keywords
This publication has 18 references indexed in Scilit:
- Advanced Sample Preparation Techniques Using Broad Ar Ion Beam for Optimum EBSD AcquisitionMicroscopy and Microanalysis, 2011
- Determination of crystal phase from an electron backscatter diffraction patternJournal of Applied Crystallography, 2009
- Low Energy Ga+ and Ar+ Ion Milling for Improved EBSD Sample PreparationMicroscopy and Microanalysis, 2008
- Energy-filtered electron backscatter diffractionUltramicroscopy, 2008
- Electron backscattering diffraction investigation of focused ion beam surfacesJournal of Electronic Materials, 2002
- Ionised cluster beams as a hardness measurement toolNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 1999
- Measurement of crystal parameters on backscatter kikuchi diffraction patternsScanning, 1998
- Image Contrast and Signal Processing1998
- Ripple Structure on Ag(110) Surface Induced by Ion SputteringPhysical Review Letters, 1997
- Sputtering—a review of some recent experimental and theoretical aspectsApplied Physics A, 1975