Microstructure and fracture performance of 304 stainless steel laser repairs with Al2O3 nano-particles
Authors:
- 4 February 2019
- journal article
- research article
- Published by Walter de Gruyter GmbH in Materials Testing
- Vol. 61 (2) , 125-130
Abstract
Pre-cracked 304 stainless steel compact tension specimens were repaired by a CO2 laser at the crack tips with the addition of different weight fractions of nano-Al2O3. Crack opening displacements were measured by a digital image correlation system for the evaluation of fracture performance. Microstructures of the repaired areas were examined by scanning electron microscopy equipped with an energy dispersive spectrometer. Results indicated that laser repair with the addition of 1.0 wt.-% nano-Al2O3 resulted in metallurgical bonding at the interface and fine columnar crystal in the repair layer. The addition of nano-Al2O3 increases sites of heterogeneous nucleation, which acts as a fine-grain strengthener. In addition, the uniform distribution of nano-Al2O3 plays a role in dispersion strengthening, resulting in improved fracture performance by approximately 10 % to 30 % as applied loads varied from 1 to 20 kN. However, the excessive addition of nano-Al2O3 gives rise to the agglomeration and micro-cracks in the repair layers and clear detachment are observed at the interface.Keywords
This publication has 14 references indexed in Scilit:
- Effect of laser clad repair on the fatigue behaviour of ultra-high strength AISI 4340 steelMaterials Science and Engineering: A, 2014
- Nano-Borides and Silicide Dispersed Composite Coating on AISI 304 Stainless Steel by Laser-Assisted HVOF Spray DepositionJournal of Thermal Spray Technology, 2014
- Dry sliding tribological behavior and mechanical properties of Al2024–5wt.%B4C nanocomposite produced by mechanical milling and hot extrusionMaterials & Design (1980-2015), 2014
- Some Size and Quantum Effects in Molecular NanostructuresMaterials Science Forum, 2012
- Laser Metal Deposition as Repair Technology for Stainless Steel and Titanium AlloysPhysics Procedia, 2012
- Microstructural evolution of AISI 4340 steel during Direct Metal Deposition processMaterials Science and Engineering: A, 2011
- Crack Free Tungsten Carbide Reinforced Ni(Cr) Layers obtained by Laser CladdingPhysics Procedia, 2011
- Effects of CeO2 nanoparticles on microstructure and properties of laser cladded NiCoCrAlY coatingsJournal of Rare Earths, 2010
- Effect of nano-CeO2 on cobalt-based alloy laser coatingsJournal of Materials Processing Technology, 2008
- Morphology and characterization of laser clad composite NiCrBSi–WC coatings on stainless steelSurface and Coatings Technology, 2006