Noise sources in microelectromechanical systems
Author:
- 7 November 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 85-96
Abstract
It is well known that several mechanisms of noise generation appear in microelectronic devices, causing thermal noise, shot noise, generation-recombination noise and 1/f noise. Besides of these noises, in the case of microelectromechanical systems specific additional noises appear as a consequence of the fact that the "building blocks" (microcantilevers or membranes) of micromechanical systems have very small geometrical dimensions and mass. Most often these noises are the consequences of temperature fluctuations caused by dissipative processes in various vibrational structures within the micromechanical systems. This work presents methodology of calculation of noises characteristic microelectromechanical systems and apples it to calculation of limiting performances of accelerometers, sensing probe cantilevers and thermal infrared detectors.Keywords
This publication has 20 references indexed in Scilit:
- Micromechanical resonators for oscillators and filters2002
- The influence of gas-surface interaction on gas-film damping in a silicon accelerometerSensors and Actuators A: Physical, 1998
- Dissipation mechanisms in pendulums and their implications for gravitational wave interferometersReview of Scientific Instruments, 1998
- Equivalent circuit representation of electromechanical transducers: II. Distributed-parameter systemsJournal of Micromechanics and Microengineering, 1997
- Multi-mode noise analysis of cantilevers for scanning probe microscopyJournal of Applied Physics, 1997
- Thermal characterization of surface-micromachined silicon nitride membranes for thermal infrared detectorsJournal of Microelectromechanical Systems, 1997
- 6-MHz 2-N/m piezoresistive atomic-force microscope cantilevers with INCISIVE tipsJournal of Microelectromechanical Systems, 1997
- Uncooled thermal imaging with monolithic silicon focal planes1993
- Resonator surface contamination-a cause of frequency fluctuations?IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1989
- Irreversibility and Generalized NoisePhysical Review B, 1951