Development and performance of a continuous industrial microwave dryer for remediation of drill cuttings
Authors:
- Irineu PetriIPIrineu Petri
- André L. MartinsAMAndré L. Martins
- Claudio R. DuarteCDClaudio R. Duarte
- Carlos H. AtaídeCACarlos H. Ataíde
- 1 May 2019
- journal article
- research article
- Published by Elsevier in Journal of Petroleum Science and Engineering
- Vol. 176, 362-368
Abstract
No abstract availableKeywords
Funding Information
- Coordination for the Improvement of Higher Education Personnel
- Foundation for Research Support of Minas Gerais (FAPEMIG)
- National Council for Scientific and Technological Development
- Brazilian Petroleum S.A. (PETROBRAS)
This publication has 11 references indexed in Scilit:
- The study on pyrolysis of oil-based drilling cuttings by microwave and electric heatingJournal of Environmental Management, 2018
- Influence of Rock Chemical Composition in Microwave Heating and Decontamination of Drill CuttingsMaterials Science Forum, 2017
- Microwave drying remediation of petroleum-contaminated drill cuttingsJournal of Environmental Management, 2017
- Development and evaluation of a continuous microwave processing system for hydrocarbon removal from solidsChemical Engineering Journal, 2016
- Microwave remediation of oil well drill cuttingsJournal of Petroleum Science and Engineering, 2015
- DECONTAMINATION OF DRILLED CUTTINGS BY MICROWAVE DRYING: KINETICS ASPECTSBrazilian Journal of Petroleum and Gas, 2015
- Microwave Drying of Drilled Cuttings in the Context of Waste Disposal and Drilling Fluid RecoveryEnergy Technology, 2014
- Microwave treatment of drilled cuttings contaminated by synthetic drilling fluidSeparation and Purification Technology, 2014
- Scale-up and design of a continuous microwave treatment system for the processing of oil-contaminated drill cuttingsChemical Engineering Research and Design, 2010
- Remediation of oil-contaminated drill cuttings using continuous microwave heatingChemical Engineering Journal, 2009