Investigation of the formation of microstructure and strength characteristics of slag-alkaline arbolite
Open Access
- 22 March 2023
- journal article
- research article
- Published by OU Scientific Route in EUREKA: Physics and Engineering
- No. 2,p. 209-221
Abstract
The creation of the slag-alkaline arbolite's structure is examined in this study, which is based on measurements of the deformation of the mortar component, contact zone, and filler. Composites made of slag and alkaline arbolite are among the lightest building materials available, with excellent sound insulation and low thermal conductivity. Standard measuring equipment and procedures for analyzing the chemical and physico-mechanical properties of slag-alkaline arbolite composites were employed during the experimental tests. All of the test samples were light concrete prisms with a cross section of 150x150 mm and a length of 600 mm. For comparison, one portion of the samples was constructed of slag-alkaline Portland cement, and the other portion was made of slag-alkaline binder with crushed cotton stem fibers as an organic component. The durability and deformability of arbolite were tested under Kazakhstan weather conditions and in standard hardening chambers. The arbolite underwent a compression stress that ranged from (0.3 to 0.75) Rbn of prismatic strength. It was discovered that the organic cellulose filler added to the slag-alkaline binder based on crushed cotton stalk fiber, which makes up to 70 % of the volume, has a major impact on the way structures are formed. The system becomes rigid, the elasticity changes, and the acoustic properties in this case will fix both physical and physico-chemical processes when a porous organic filler is added. The acquired results can be applied to the creation of efficient wall materials for civil buildings, including seismic zonesKeywords
This publication has 10 references indexed in Scilit:
- Improvement of Strength Properties of Arbolite Concrete Composites by Impregnation with Sulfur—By-Products of Oil and Gas Industry2022
- The Study of the Impact of Iron and Sulfur Containing Additives on the Strength Properties of Sulfur Containing BindersSolid State Phenomena, 2022
- MECHANICAL PROPERTIES OF FIBER CONCRETE UNDER DYNAMIC COMPRESSIONProblems of Strength and Plasticity, 2022
- The Study of Creep and Deformation Properties of Sulfur-Containing Arbolit Exposed to Various Compression StressesKey Engineering Materials, 2021
- DETOXICATION OF BY-PRODUCTS OF OIL AND GAS INDUSTRY ACCOMPANIIED BY OBTAINING IRON AND SULFUR-CONTAINING BINDERS FOR STRUCTURAL BUILDING MATERIALSSERIES CHEMISTRY AND TECHNOLOGY, 2020
- FORMATION OF STRENGTH AND PHASES OF SEQUENCE OF DESTRUCTION OF ARBOLITE COMPOSITES AT VARIOUS LONG LOADSSeries of Geology and Technical Sciences, 2020
- The study of structure formation and mechanical strength properties of sulfur-containing woodcrete composites exposed to permanently acting loadsIOP Conference Series: Materials Science and Engineering, 2020
- PREPARATION OF CARBON NANOCOMPOSITES ON THE BASIS OF SILICON-TIN CONTAINING SUBSTANCESSeries of Geology and Technical Sciences, 2019
- OBTAINING AND RESEARCH OF PHYSICAL AND CHEMICAL PROPERTIES OF CHELATED POLYMER-CONTAINING MICROFERTILIZERS ON THE BASIS OF TECHNOGENIC WASTE FOR RICE SEED BIOFORTIFICATIONSeries of Geology and Technical Sciences, 2019
- INFLUENCE OF COMPONENTS OF LIGHTWEIGHT CONCRETE ON STRENGTH AND DEFORMATION CHARACTERISTICSВестник Белорусско-Российского университета, 2018