Biomechanical analysis of materials handling manipulators in short distance transfers of moderate mass objects: joint strength, spine forces and muscular antagonism
Authors:
- Maury A. NussbaumMNMaury A. Nussbaum
- Don B. ChaffinDCDon B. Chaffin
- Gerri BakerGBGerri Baker
- 1 December 1999
- journal article
- clinical trial
- Published by Taylor & Francis in Ergonomics
- Vol. 42 (12) , 1597-1618
Abstract
Although often suggested as a control measure to alleviate musculoskeletal stresses, the use of mechanical assistance devices (i.e. manipulators) in load transfers has not been extensively studied. Without data describing the biomechanical effects of such devices, justification for decisions regarding implementation of such tools is difficult. An experimental study of two types of mechanical manipulators (articulated arm and overhead hoist) was conducted to determine whether biomechanical stresses, and hence injury risk, would be alleviated. Short distance transfers of loads with moderate mass were performed both manually and with manipulator assistance under a variety of task conditions. Using analysis and output from new dynamic torso models, strength demands at the shoulders and low back, lumbar spine forces, and lumbar muscle antagonism were determined. Strength requirements decreased significantly at both the shoulders and low back when using either manipulator in comparison with similar transfers performed manually. Peak spine compression and anteriorposterior (a-p) shear forces were reduced by about 40% on average, and these reductions were shown to be primarily caused by decreases in hand forces and resultant spinal moments. Two metrics of muscular antagonism were defined, and analysis showed that torso muscle antagonism was largest overall when using the hoist. The results overall suggest that hoist-assisted transfers, although better in reducing spine compression forces, may impose relatively higher demands on coordination and/or stability at extreme heights or with torso twisting motions. The relatively higher strength requirements and spine compression associated with the articulated arm may be a result of the high inertia of the system. Potential benefits of practice and training are discussed, and conclusions regarding implementation of mechanical manipulators are given.Keywords
This publication has 29 references indexed in Scilit:
- Low-back stresses when learning to use a materials handling deviceErgonomics, 1999
- An EMG-assisted model of trunk loading during free-dynamic liftingJournal of Biomechanics, 1995
- Muscle lines-of-action affect predicted forces in optimization-based spine muscle modelingJournal of Biomechanics, 1995
- DYNAMIC PUSH AND PULL FORCES WHILE USING A MANUAL MATERIAL HANDLING ASSIST DEVICEIIE Transactions, 1994
- An EMG-assisted model of loads on the lumbar spine during asymmetric trunk extensionsJournal of Biomechanics, 1993
- A method for studying the biomechanical load response of the (in vitro) lumbar spine under dynamic flexion-shear loadsJournal of Biomechanics, 1993
- A myoelectrically based dynamic three-dimensional model to predict loads on lumbar spine tissues during lateral bendingJournal of Biomechanics, 1992
- Poor results of bovine xenograft for knee cruciate ligament repairActa Orthopaedica, 1989
- Isometric and isokinetic back and arm lifting strengths: Device and measurementJournal of Biomechanics, 1988
- Approaches to preplacement testing and selection of workersErgonomics, 1987