The Effect of Using the Flow Separator Blade to Increase the Uniformity of Flow in the Intake Manifold
Authors:
Open Access
- 5 December 2019
- journal article
- research article
- Published by Oxford University Press (OUP) in Journal of Mechanics
- Vol. 35 (6) , 875-885
Abstract
In this paper, an idea to make the flow uniform inside the manifolds of four and six cylinder engines without changing their main geometries is presented. In general the uniform distribution of air flow among the engine cylinders is very important. Non-uniform flow in the intake manifold outlets causes inadequate feeding of the cylinders, inappropriate combustion and reduces engine volumetric efficiency. So this matter is vital for improving engine performance. A flow guide blade is added into the manifold and uniformity of the air flow is studied in different regime using transient numerical simulations. The amount of air exited from each outlet and the effect of this blade on flow uniformity is investigated. The results showed that the blade has made the flow more uniform in the manifold outlets and it was also found that in the four-cylinder and six-cylinder engines the flow uniformity is increased by 67% and 75%, respectively. In other words, as the number of engine cylinders increase, the effect of using this blade increases.Keywords
This publication has 20 references indexed in Scilit:
- A manifold design problem for a plate-fin microdevice to maximize the flow uniformity of systemInternational Journal of Heat and Mass Transfer, 2016
- Volumetric intake flow measurements of an IC engine using magnetic resonance velocimetryExperiments in Fluids, 2014
- Flow decomposition methods applied to the flow in an IC engine manifoldApplied Thermal Engineering, 2014
- Influence of intake pipe length and diameter on the performance of a spark ignition engineJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2013
- Influence of intake manifold design on in-cylinder flow and engine performances in a bus diesel engine converted to LPG gas fuelled, using CFD analyses and experimental investigationsEnergy, 2011
- Theory of flow distribution in manifoldsChemical Engineering Journal, 2011
- Design of a new SI engine intake manifold with variable length plenumEnergy Conversion and Management, 2010
- Flow field development in a direct injection diesel engine with different manifoldsInternational Journal of Engineering, Science and Technology, 2010
- Intake system design procedure for engines with special requirementsProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2006
- CFD-based optimal design of manifold in plate-fin microdevicesChemical Engineering Journal, 2004