Triple-Mode Active-Passive Parallel Intermediate Links Converter With High Voltage Gain and Flexibility in Selection of Duty Cycles
Open Access
- 20 July 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 134716-134727
Abstract
A high number of research work is being carried out in the field of DC-DC converters to improve the performance of microgrid operation. The DC microgrid has a high level of acceptance because of the integration of renewable energy sources. In DC Microgrid, there is a need for improved DC-DC converter topologies which offer high gain, small size, enhanced efficiency, reduced voltage stress and reduced component count etc. A new Triple-Mode Active-Passive Parallel Intermediate Links (TM-A2P-IL) converter is proposed in the paper. The A2P-IL is designed by a combination of an inductor, capacitor, diode, and control switch. The proposed converter is derived by inserting A2P-IL in conventional boost converter. The proposed TM-A2P-IL converter operates in three modes and provides a high voltage gain without using a transformer, voltage multiplier stages, coupled inductor, switched inductor/capacitor circuitry. The other benefits of the proposed TM-A2P-IL converters are flexibility in the selection of duty cycles, reduced voltage stress of devices, small reactive components, single-stage power conversion. The proposed converter circuit, operating principle, steady-state analysis is studied for both CCM and DCM, discussed. The comparison between available similar type converters and the proposed converter is provided. The operation and performance of the proposed A2P-IL converter are validated through simulation and experimental work.Keywords
Funding Information
- Danida Mobility Grant, responsible for the Ministry of Foreign Affairs of Denmark (MFA), Act 7 on Denmark’s International Development Cooperation (19-MG04AAU)
This publication has 38 references indexed in Scilit:
- Steady-State Analysis of Inductor Conduction Modes in the Quadratic Boost ConverterIEEE Transactions on Power Electronics, 2016
- High Step-Up Trans-Inverse (Tx−1) DC–DC Converter for the Distributed Generation SystemIEEE Transactions on Industrial Electronics, 2016
- The Hybrid-Cascaded DC–DC Converters Suitable for HVdc ApplicationsIEEE Transactions on Power Electronics, 2015
- A New Isolated Auxiliary Current Pump Module for Load Transient Mitigation of Isolated/Nonisolated Step-Up/Step-Down DC–DC ConverterIEEE Transactions on Power Electronics, 2015
- Isolated DC/DC Structure Based on Modular Multilevel ConverterIEEE Transactions on Power Electronics, 2015
- A Fully Soft-Switched Single Switch Isolated DC–DC ConverterIEEE Transactions on Power Electronics, 2014
- A DC–DC multilevel boost converterIET Power Electronics, 2010
- An Interleaved Boost Converter With Zero-Voltage TransitionIEEE Transactions on Power Electronics, 2009
- Boost Converter With Coupled Inductors and Buck–Boost Type of Active ClampIEEE Transactions on Industrial Electronics, 2008
- Analysis of Luo converters with voltage-lift circuitIEE Proceedings - Electric Power Applications, 2005