Theoretical Evaluation of Strengthening Ability of Phase Interfaces in Lamellar Ti Alloys
Authors:
- 14 December 2021
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 24 (8)
Abstract
Strengthening abilities (Hall–Petch coefficients) and the barrier strength of α/β lamellar interfaces and coarse primary/fine secondary α lamellae interfaces in Ti alloys are theoretically estimated based on the lattice and modulus mismatches of two phases on both sides of the interfaces. The results reveal that the strengthening abilities of the α/β lamellar interfaces and the coarse primary/fine secondary α lamellae interfaces are about 272.6 and 68.9 MPa, respectively, and the interface barrier strength of the α/β lamellar interface is about 9.5 times higher than that of the coarse primary/fine secondary α lamellae interface. The variation trend of the interface strengthening abilities with the fraction of α/β interfaces for lamellar Ti alloys is found. The finding may provide a potential strategy for enhancing the strength or deformability of lamellar Ti alloys through manipulating interface properties.Keywords
Funding Information
- National Natural Science Foundation of China (52171128, 51771207, 51971060)
This publication has 43 references indexed in Scilit:
- Analysis of slip transfer and deformation behavior across the α/β interface in Ti–5Al–2.5Sn (wt.%) with an equiaxed microstructureMaterials Science and Engineering: A, 2012
- Texture and microtexture variations in a near-α titanium forged disk of bimodal microstructureActa Materialia, 2012
- Thermal expansion and lattice parameters of shaped metal deposited Ti–6Al–4VJournal of Alloys and Compounds, 2011
- Slip Deformation Analysis Based on Full Constraints Model for α-Titanium Alloy at Low TemperatureMATERIALS TRANSACTIONS, 2011
- Texture development in Ti–6Al–4V linear friction weldsMaterials Science and Engineering: A, 2007
- Measurement of single-crystal elastic constants by neutron diffraction from polycrystals. Addendum and erratumJournal of Applied Crystallography, 2000
- Room temperature deformation and mechanisms of slip transmission in oriented single-colony crystals of an α/β titanium alloyActa Materialia, 1999
- Influence of processing on microstructure and mechanical properties of (α+β) titanium alloysMaterials Science and Engineering: A, 1998
- Attempt to Design a Strong SolidPhysical Review B, 1970
- The Distribution of Dislocations in an Elliptical Glide ZonePhysica Status Solidi (b), 1963