Statistical Comparison of Processing Different Powder Feedstock in an HVOF Thermal Spray Process
Open Access
- 12 April 2022
- journal article
- research article
- Published by Springer Nature in Journal of Thermal Spray Technology
- Vol. 31 (5) , 1476-1489
Abstract
Cermet coatings such as WC-Co and Cr3C2-NiCr are frequently applied by means of thermal spray processes to protect highly stressed surfaces against wear. The investigation of the respective spray materials and their coating properties and in-flight particle properties are often carried out in separate experiments. In this study, the coating characteristics (hardness, deposition rate, porosity, thickness) and in-flight particle properties (particle velocity and temperature) of three different WC-based powders and a Cr3C2-NiCr powder processed by means of an HVOF process are investigated as a function of some key process parameters such as kerosene flow rate, lambda, spray distance and feeder disc velocity. These parameters were varied within a design of experiments, whilst all other parameters were fixed. Both the design of experiments plan and the settings of the fixed parameters were defined identically. The in-flight particle properties and coating characteristics are statistically modeled as a function of the process parameters and their influences are compared. A well-selected, limited number of experimental runs using statistical design of experiment (DoE) enable this comparison. The deployed statistical models are generalized linear models with Gamma-distributed responses. The models show that particle velocity and particle temperature mainly depend on kerosene flow rate and spray distance. However, in the case of particle temperature, the model coefficients for Cr3C2-NiCr and WC powders have different signs, reflecting different qualitative behavior.Keywords
Funding Information
- Technische Universität Dortmund
This publication has 25 references indexed in Scilit:
- Warm spraying—a novel coating process based on high-velocity impact of solid particlesScience and Technology of Advanced Materials, 2008
- Design of experiments in thermal spraying: A reviewSurface and Coatings Technology, 2008
- Effects of carbide size and Co content on the microstructure and mechanical properties of HVOF-sprayed WC–Co coatingsSurface and Coatings Technology, 2007
- Effect of carbide grain size on microstructure and sliding wear behavior of HVOF-sprayed WC–12% Co coatingsWear, 2003
- Dominant effect of carbide rebounding on the carbon loss during high velocity oxy-fuel spraying of Cr3C2–NiCrThin Solid Films, 2002
- In-flight oxidation of composite powder particles during thermal sprayingInternational Journal of Heat and Mass Transfer, 2001
- Influence of thermal processes on coating formation during high velocity oxy-fuel (HVOF) spraying of WC-Ni powder particlesSurface and Coatings Technology, 1996
- Abrasion, erosion and scuffing resistance of carbide and oxide ceramic thermal sprayed coatings for different applicationsWear, 1993
- A note on a general definition of the coefficient of determinationBiometrika, 1991
- Estimating the Dimension of a ModelThe Annals of Statistics, 1978