A Method to Identify Different Comb Gaps for MEMS Gyroscope at the Wafer Level Based on Negative Electrostatic Stiffness
- 21 April 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (11) , 11522-11531
Abstract
For high-accurate micro-electro-mechanical systems (MEMS) gyroscopes, comb gap errors influence the mechanical coupling errors and limit performance. In this study, an in situ method was proposed to identify the gaps of drive combs, drive-sense combs, and sense combs in MEMS gyroscopes that can be applied at the wafer level. Negative electrostatic stiffness of combs was considered in the model construction of the sense mode and the Y-axis in-phase mode, and the frequency change caused by this was applied to characterize the comb gaps. Eight chips in different positions of a wafer were selected for verification of this method. The results shows that errors of drive comb gaps, drive-sense comb gaps, and sense comb gaps in the chip near the wafer center were 0.67 μm, 0.60 μm, and 0.53 μm, respectively, and those in the chip at the wafer edge were 0.96 μm, 0.95 μm, and 0.71 μm, respectively. The variation of comb gaps was 0.08 μm in a single chip near the wafer center, and 0.03 μm in a single chip at the wafer edge. This work provides a method for the fabless designers to explore the effect of wafer process on the structures and reduce it through careful design.Keywords
Funding Information
- National Natural Science Foundation of China (62074078)
This publication has 22 references indexed in Scilit:
- Quadrature-Error Compensation and Corresponding Effects on the Performance of Fully Decoupled MEMS GyroscopesJournal of Microelectromechanical Systems, 2012
- Zero-Rate Output and Quadrature Compensation in Vibratory MEMS GyroscopesIEEE Sensors Journal, 2007
- Mechanical-electrostatic coupling research for MEMS line vibration gyroscope2006
- A digital holographic microscope for complete characterization of microelectromechanical systemsMeasurement Science and Technology, 2004
- Fabrication of high-aspect ratio, micro-fluidic channels and tunnels using femtosecond laser pulses and chemical etchingOptics Express, 2004
- Characterization of micromechanical structures using white-light interferometryMeasurement Science and Technology, 2003
- Microscopic surface contouring by fringe projection methodOptics & Laser Technology, 2002
- Effect of process parameters on the surface morphology and mechanical performance of silicon structures after deep reactive ion etching (DRIE)Journal of Microelectromechanical Systems, 2002
- Characterization of TiNi shape-memory alloy thin films for MEMS applicationsSurface and Coatings Technology, 2001
- Evaluation of size effect on mechanical properties of single crystal silicon by nanoscale bending test using AFMJournal of Microelectromechanical Systems, 2000