A dual-mode thickness-shear quartz pressure sensor
Authors:
- R.J. BessonRBR.J. Besson
- B. GlotinBGB. Glotin
- Y. JinzakiYJY. Jinzaki
- B. SinhaBSB. Sinha
- M. ValdoisMVM. Valdois
- 1 September 1993
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 40 (5) , 584-591
Abstract
The development of a dual-mode thickness-shear quartz pressure sensor to meet the demanding performance requirements of oil-field applications is discussed. The objective was to develop a sensor with an operating pressure range of 0-103.42 MPa (0.15 000 lb/in/sup 2/), a temperature range of -10 to +175 degrees C, a pressure calibration accuracy of 6894.8 Pa (1 lb/in/sup 2/), and resolution of 68.95 Pa (0.01 lb/in/sup 2/) with 1-s counter gate time. Doubly rotated cuts with piezoelectric coupling to both the C-modes of vibration were investigated. A theoretical study and general design considerations in the development of such sensors are described. Experimental results were obtained for two sensor designs: one uses a cylindrical design with the SBTC-cut, and the other, called SPA, is a special resonator design vibrating around 5 MHz without any activity dips. Pressure sensitivity of approximately 145 Hz/MPa (1 Hz/lb/in/sup 2/) at 175 degrees C is obtained. Laboratory evaluation of the static and dynamic performances is discussed for the prototypes based on the SPA design.<>Keywords
This publication has 16 references indexed in Scilit:
- Experimental verification of stress compensation in the SBTC-cutIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1989
- Survey of quartz bulk resonator sensor technologiesIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1988
- Force Sensitivity of Trapped Energy Vibrations in a Contoured Resonator1987
- A Reduced Hysteresis, Extended Range Quartz Pressure Transducer1987
- Jumps in Frequency Temperature Response of Contoured Resonators: An Analysis Performed with a Perturbation Model and X-Ray Patterns1984
- Simplified Expressions for the Stress-Frequency Coefficients of Quartz PlatesIEEE Transactions on Sonics and Ultrasonics, 1984
- Elastic waves in crystals under a biasFerroelectrics, 1982
- Stress Compensated Orientations for Thickness-Shear Quartz Resonators1981
- Stress Induced Frequency Shifts in Thickness-Mode Quartz Resonators1980
- Dual Mode Operation of Temperature and Stress Compensated Crystals1978