Minimum and Complete Fluidization Velocity for Sand-Palm Shell Mixtures, Part I: Fluidization Behavior and Characteristic Velocities
Authors:
- ChokCHChok
- V. S. ChokVCV. S. Chok
- A. GorinAGA. Gorin
- H. B. ChuaHCH. B. Chua
Open Access
- 1 June 2010
- journal article
- Published by Science Publications in American Journal of Applied Sciences
- Vol. 7 (6) , 763-772
Abstract
Problem statement: Palm shell on its original state cannot be fluidized solely. However, mixing palm shell with a second fluidizable material can facilitate proper fluidization. Approach: The minimum and complete fluidization velocity (Umf and Ucf) for sand/palm shell binary mixtures had been studied in a partitioned reactor known as Compartmented Fluidized Bed Gasifier (CFBG). The pilot scale reactor ID is 66 cm with 60:40 cross sectional area ratio for combustor and gasifier respectively. The bed materials constitute of sand and palm shell up to 15 weight percent (wt%). The particle size and density ratio for palm shell and sand are about 5÷53 and 0.55 respectively. Results: Despite of the unique reactor feature, the mixture bed pressure drop profiles were closely resemble to those observed in the laboratory scale cylindrical column. It was found that partial fluidization occurred for the smallest sand size with any palm shell size and weight percent in the gasifier. Poor fluidization was also found with the same sand in the combustor but limited to the largest palm shell and higher weight percent. The Umf and Ucf values increase with the increase of palm shell size and weight percent in both compartments and are in tandem with the increase of effective particle diameter. However, although increase in the sand size also increased the effective particle diameter, the characteristic velocities show both increasing and decreasing trends. These findings proved that the characteristic velocities of the sand-palm shell binary mixtures not only depend on the effective bed properties, but also influenced by the mixing/segregating condition. In addition, bed geometry is an equally important factor for the present system. Conclusion/Recommendation: Despite of the large difference in particle size and density, palm shell in sand can be fluidized well, making it a suitable biomass feedstock for gasification in CFBG pilot plant.Keywords
This publication has 11 references indexed in Scilit:
- Oil palm biomass as a sustainable energy source: A Malaysian case studyEnergy, 2009
- The fluidization process of binary mixtures of solids: Development of the approach based on the fluidization velocity intervalPowder Technology, 2008
- Pyrolysis of palm oil wastes for enhanced production of hydrogen rich gasesFuel Processing Technology, 2006
- Kinetic study on pyrolytic process of oil-palm solid waste using two-step consecutive reaction modelBiomass and Bioenergy, 2001
- The behaviour of large jetsam particles in fluidised bedsPowder Technology, 1987
- Fluidization velocities of sand/straw binary mixturesPowder Technology, 1987
- Comments on buoyancy in fluidized bedsChemical Engineering Science, 1987
- Minimum fluidization velocity at high temperaturesIndustrial & Engineering Chemistry Process Design and Development, 1981
- Particle mixing and segregation in gas fluidised beds. A reviewPowder Technology, 1976
- A generalized method for predicting the minimum fluidization velocityAIChE Journal, 1966